ProForm 7.0 Re Elliptical English Manual - Page 5

PART IDENTIFICATION CHART Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. Extra parts may be included. M8 Locknut (77)–-8 M6 x 18mm Washer (55)–-2 M8 Washer (33)–-2 M4 x 16mm Screw (64)–-11 M6 x 18mm Screw (80)–-2 M8 x 20mm Screw (79)–-8 M8 x 35mm Bolt (76)–-8 M10 x 35mm Screw (75)–-6 M10 x 93mm Screw (78)–-4 5