ProForm 755 Crosstrainer Treadmill English Manual - Page 7

2. With the help of a second person, carefully tip the treadmill onto its right side as shown. Insert the other Extension Leg (89) into the base of the Uprights (84) as shown. Hold two Extension Leg Nuts (67) in the bottom of the Extension Leg. Next, insert two Base Leg Bolts (65) into the top of the Extension Leg, and firmly tighten the Base Leg Bolts into the Extension Leg Nuts. Attach two Base Pads (82) to the base of the Uprights (84) with two 3/4" Tek Screws (22). With the help of a second person, carefully raise the treadmill so that all four Base Pads (82) are on the floor and the Uprights (84) are in a vertical position (see drawing 4). 3. Identify the Latch Assembly (29). Make sure that the sleeve on the Latch Assembly (29) is covering hole 1 and that the Latch Knob (97) is engaged in hole 1. If necessary, slide the sleeve over hole 1 and engage the Latch Knob into hole 1. Then, pull the sleeve to make sure that it is locked in place. Next, make sure that the Latch Knob (97) is also engaged in hole 2. If it is not, pull out the tube until you see hole 2, and then slide the tube back into the large barrel until the Latch Knob engages in hole 2. 2 84 65 82 82 22 67 89 3 Hole 2 97 Tube Sleeve Hole 1 29 Large Barrel 4. Remove the plastic ties from the ends of the Latch Assembly (29). 4 Orient the Latch Assembly (29) so that the large barrel and the Latch Knob (97) are positioned as shown; make sure that all of the holes are aligned (see the inset drawings). Attach the lower end of the Latch Assembly to the bracket on the Upright (84) with the Lower Latch Bolt (39) and a Latch Nut (30). Then, attach the upper end of the Latch Assembly (29) to the bracket on the Frame (58) with the Upper Latch Bolt (50) and a Latch Nut (30). Note: It may be necessary to move the Frame back and forth to align the Latch Assembly with the bracket. 58 30 50 97 29 Large Barrel 84 30 39 Top Holes Holes Bottom 7