ProForm Crosswalk 480 Treadmill Canadian English Manual - Page 10
Bolt 7, and M10 Star Washer 8.
View all ProForm Crosswalk 480 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
8. Hold a Bolt Spacer (98) inside the lower end of the Left Upright (79). Insert an M10 x 96mm Bolt 8 (7) with an M10 Star Washer (8) into the Left Upright and the Bolt Spacer. Repeat this step 7 79 with a second Bolt Spacer (98), M10 x 96mm Bolt (7), and M10 Star Washer (8). 8 Orient the Left Upright Spacer (89) and the Left Upright (79) as shown. Hold the Left Upright Spacer and the Left Upright against the Base (99). Tighten the M10 x 96mm Bolts (7) until the heads of the Bolts touch the Left Upright; do not fully tighten the Bolts yet. 98 89 99 9. Press a Base Cap (91) into the Base (99). 9 With the help of a second person, tip the treadmill so that the Base (99) is flat on the floor. 91 99 10. Set the console assembly face down on a soft surface to avoid scratching the console assembly. Identify the Right Handrail (100) which is marked with a sticker. Hold the Right Handrail near the console assembly. Attach the console ground wire to the Right Handrail with a #8 x 1/2" Ground Screw (29). Next, insert the console wire into the large hole in the Right Handrail (100) and out of the top as shown. Attach the Right Handrail with three M4.2 x 19mm Screws (1). Make sure that no wires are pinched. Start all three Screws before tightening any of them; do not overtighten the Screws. Remove the ties from the two M8 Cage Nuts (39). If necessary, press the Cage Nuts back into place. 10 1 100 39 Console Ground Wire Console Assembly 29 10 Console Wire 1 Large Hole 1