ProForm Crosswalk 480 Treadmill Canadian English Manual - Page 24

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION:

a.

If the walking belt is off-center,

first remove the

key and

UNPLUG THE POWER CORD. If the

walking belt has shifted to the left,

use the hex

key to turn the left idler roller bolt clockwise 1/2 of a

turn;

if the walking belt has shifted to the right,

turn the bolt counterclockwise 1/2 of a turn. Be

careful not to overtighten the walking belt. Then,

plug in the power cord, insert the key, and run the

treadmill for a few minutes. Repeat until the walk-

ing belt is centered.

b.

If the walking belt slips when walked on,

first re-

move the key and

UNPLUG THE POWER CORD.

Using the hex key, turn both idler roller bolts clock-

wise, 1/4 of a turn. When the walking belt is cor-

rectly tightened, you should be able to lift each side

of the walking belt 2 to 3 in. (5 to 7 cm) off the

walking platform. Be careful to keep the walking

belt centered. Then, plug in the power cord, insert

the key, and carefully walk on the treadmill for a

few minutes. Repeat until the walking belt is prop-

erly tightened.

PROBLEM: The crosswalk arms squeak during use

SOLUTION:

a. (Note: Correcting this problem requires a small

amount of white marine grease, available at hard-

ware stores.) Turn the Resistance Knob (88) coun-

terclockwise and remove it. Next, remove the

Resistance Cone (85) with the Crosswalk Arm

(82).

Apply a

thin layer

of white marine grease to the

outer surface of the Resistance Cone (85). Then,

reattach the Resistance Cone with the Crosswalk

Arm (82) and the Resistance Knob (88).

24

a

b

88

82

85

a

ProForm Crosswalk 480 Treadmill Canadian English Manual - Page 24

Unplug The Power Cord. If

Page 24 highlights