ProForm Crosswalk 480 Treadmill Canadian English Manual - Page 8
mm Bolt 7, and M10 Star Washer 8.
View all ProForm Crosswalk 480 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3. Remove the M10 Locknut (36), the M10 x 50mm 3 Bolt (26), and the shipping bracket (C) from the Base (99). Attach a Wheel (95) with the Bolt and the Locknut that you just removed. Do not over- tighten the Locknut; the Wheel must turn freely. Discard the shipping bracket. 26 C 36 99 95 4. Identify the Right Upright (80) and the Right Upright Spacer (90), which are marked with stickers. Insert the Wire Harness (92) through the Right Upright Spacer (90) as shown. Then, set the Right Upright Spacer on the Base (99). Be careful not to pinch the Wire Harness. Have a second person hold the Right Upright (80) near the Base (99). See the inset drawing. Tie the wire tie in the Right Upright securely around the end of the Wire Harness (92). Then, pull the other end of the wire tie until the Wire Harness is routed completely through the Right Upright. 4 92 92 Wire Tie 80 92 90 99 80 Wire Tie 5. Hold a Bolt Spacer (98) inside the lower end of the Right Upright (80). Insert an M10 x 96mm 5 Bolt (7) with an M10 Star Washer (8) into the Right Upright and the Bolt Spacer. Repeat this step with a second Bolt Spacer (98), M10 x 96mm Bolt (7), and M10 Star Washer (8). Hold the Right Upright (80) against the Right Upright Spacer (90). Be careful not to pinch the Wire Harness (92). Tighten the M10 x 96mm Bolts (7) until the heads of the Bolts touch the Right Upright; do not fully tighten the Bolts yet. 7 80 8 92 98 90 8