ProForm G720 Bench Uk Manual - Page 10

14. Lay the Cable (49) over a Pulley (45). Attach the Pulley, a Cable Trap (53), two Bushings (46), and two M10 Washers (6) to the Lat Tower (41) with an M10 x 85mm Bolt (58) and an M10 Nylon Locknut (11). Make sure that the Cable Trap is oriented to hold the Cable in place, as shown. 14 53 46 6 11 45 46 6 41 49 58 15. Press Oval Bushings (44) into the top and bottom of the Weight Carriage (42). Press a 25mm Round Inner Cap (36) into each end of the weight tube on the Weight Carriage. Insert an M10 x 20mm Bolt (50) into the bracket on the Weight Carriage (42). Slide the Weight Carriage onto the bottom of the Lat Tower (41). Make sure that the Weight Carriage is oriented as shown. Slide the loop on the Cable (49) onto the M10 x 20mm Bolt (50) and secure it with an M10 Nylon Locknut (11). 16. Attach the Plastic Stop (37) to the Curl Bar Tube (34) with the ST4 x 15mm Screw (57). Lubricate two M10 x 70mm Bolts (28) with grease. Attach the Curl Bar Tube (34) to the Leg Lever (7) with an M10 x 70mm Bolt and an M10 Nylon Locknut (11). Attach the Curl Bar (51) to the Curl Bar Tube (34) with the other M10 x 70mm Bolt (28) and an M10 Nylon Locknut (11). Do not overtighten the M10 Nylon Locknuts (11); the Curl Bar Tube (34) must be able to pivot easily. 15 41 Bracket 36 49 11 44 44 50 42 Weight Tube 36 16 57 37 28 Lubricate Lubricate 28 51 34 11 7 11 10