ProForm Xp 185 U Bike Canadian English Manual - Page 7

4. While another person holds the Upright (3) near 4 the Frame (1), connect the Upper Wire Harness (32) to the Lower Wire Harness (31). Tip: Avoid pinching the wire harnesses during this step. Gently pull the upper end of the Upper Wire Harness (32) to remove the slack, and slide the Upright (3) onto the Frame (1). Attach the Upright with four M8 x 20mm Button Screws (35) and four M8 Split Washers (36). Avoid pinching the wire harnesses during this step 3 36 35 36 35 36 36 32 1 31 5. Identify the Right Handlebar (48), which is marked with an "R" sticker. While a second person holds the Right Handlebar near the Upright (3), tie the pull wire (see the inset drawing) to the right pulse wire, and pull it into the side of the Upright and out of the top. Then, untie and discard the pull wire. Slide the Right Handlebar (48) onto the Upright (3). Attach the Right Handlebar with two M6 x 38mm Button Bolts (53), two M6 Split Washers (43), and two M6 Nylon Locknuts (54). Make sure that the hexagonal holes are in the indicated location. Attach the Left Handlebar (47) in the same way. Orient the Water Bottle Holder (49) as shown. Insert the Upper Wire Harness (32) and the left and right pulse wires through the Water Bottle Holder. Then, slide the Water Bottle Holder onto the Upright (3) and attach it with an M4 x 16mm Screw (40). Do not tighten the Screw yet. 5 47 Left Pulse Wire Pull Wire Right Pulse Wire 40 49 32 Right Pulse Hexagonal Holes Wire 3 54 Pull Wire 48 43 53 7