ProForm Xp 185 U Bike Canadian English Manual - Page 8

6. Tip: Avoid pinching the wires during this step. Orient the Console Bracket (55) as shown and then insert the Upper Wire Harness (32) and the left and right pulse wires through the Console Bracket. Attach the Console Bracket to the Upright (3) with two M8 x 25mm Patch Screws (50). 6 50 Pulse Wires Avoid pinching the wires during this step 55 32 3 7. While another person holds the Console (6) near the Upright (3), connect the console wires to the Upper Wire Harness (32) and to the pulse wires. Tip: Avoid pinching the wires during this step. Insert the excess wires downward into the Upright (3). Attach the Console (6) to the Console Bracket (55) with four M4 x 16mm Screws (40). See step 5. Tighten the M4 x 16mm Screw (40). 7 6 Console Wires Pulse Wires 8. The Console (6) requires four 1.5V D batteries (not included); alkaline batteries are recommended. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic components. Remove the battery cover, insert the batteries into the battery compartment, and reattach the battery cover. Make sure to orient the batteries as shown by the diagram inside the battery compartment. 8 Batteries Avoid pinching the wires during this step Console Wire 32 55 3 40 Battery Cover 6 Batteries 8