RCA RT2380BK User Manual - Page 6
Inserting Batteries into Remote Control, Set up and Maintenance of the Receiver, Protect your - remote for
UPC - 044319302639
View all RCA RT2380BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
B_RT2380 EN 4/7/04 1:44 PM Page 7 Getting Started Inserting Batteries into Remote Control • Do not connect to the AC power cords until all connections are completed. Insert two "AAA" (R03) batteries according to the + and EN - signs in the battery compartment. To use the remote • Do not use your set immediately after transferring it control, point it directly at your receiver. from a cold place to a warm place: there is risk of Install batteries as follows: condensation. 1. Remove battery compartment door by applying thumb pressure on battery door and then lift the door out and off the cabinet. • Do not expose your set to water and excessively high temperatures. 2. Insert 2 AAA batteries in the compartment and replace the compartment door. • After having disconnected your set, clean the case with a soft cloth, or with a slightly damp leather chamois. Never use strong solvents. Set up and Maintenance of the Receiver Provide spaces for sufficient ventilation as indicated: 10 cm/4" 10 cm/ 4" Front View 10 cm/ 4" Protect your Components from Overheating • Do not block ventilation holes in any component. Arrange the components so that air can circulate freely. • Do not stack components directly on top of each other. 5 cm/ 2" 10 cm/4" Side View • Do not place the unit near other components that generate heat such as heating vents. • Allow adequate ventilation when placing your components in a stand. • Place an amplifier near the top shelf of the stand so heated air rising from it will not affect other components. If you have a satellite receiver, you should place it on the top shelf. 3