Samsung NX58R5601SS/AA Installation Guide - Page 26

Installation instructions Step 7. Assemble the surface burners CAUTION Do not operate the surface burners without all burner parts in place. Model NX58*565***/ NX58*751*** Model NX58*560*** 1. Position surface burner heads on top of the surface burner manifolds as shown at right. The electrodes will fit into the slot in the bottom of the heads. Make sure the surface burner heads are flat and parallel with the cooktop. 2. Place the matching size caps on top of each surface burner head. NOTE The caps on Precise simmer burner (RR) and inside Dual Burner (RF) can be interchangeably used. Precise Simmer Burner (RR) Flat surface Concave line 3. Place the left, center, and right surface burner grates on the cooktop. The edges of the grates should match up with the edges of the cooktop. Step 8. Check the ignition of surface burners and oven burners Check the operation of all cooktop and oven burners after the range has been installed and assembled, gas supply lines have been carefully checked for leaks, and electrical power cord has been plugged in. All surface and oven burners have electronic ignition. To turn on a surface burner: 1. Push in and turn the control knob for that surface burner to the LITE position. The "clicking" sound indicates the electronic ignition system is operating properly. The burner will light in about 4 seconds, after the air has been purged from the supply line. 2. After the burner lights, turn the control knob to the desired setting. The "clicking" sound will stop and the flame height will change from Max. to Min. during turning the control knob. 3. Repeat steps 1 and 2 to check the operation of each surface burner insuccession. NOTE Place food in the oven after preheating if the recipe calls for it. Preheating is important for good baking results. After the oven has reached the desired cooking temperature, it will beep 6 times. Installation instructions 26 English