Samsung RFG298HDRS User Manual (user Manual) (ver.0.2) (English, French, Spani - Page 14
Using The Cold Water, Dispenser - reset
View all Samsung RFG298HDRS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Controlling the fridge temperature The fridge temperature can be set between between 34°F and 46°F (or between 7°C and 1°C) to suit your particular needs. Press the Fridge button repeatedly until the desired temperature is shown in the temperature display. The temperature will change by 2°F (or 1°C) with each press. See below. Fahrenheit : 38°F ➞ 36°F ➞ 34°F ➞ 46°F ➞ 44°F ➞ 42°F ➞ 40°F ➞ 38°F. Centigrade : 3°C ➞ 2°C ➞ 1°C ➞ 7°C ➞ 6°C ➞ 5°C ➞ 4°C ➞ 3°C. The temperature control process for the Fridge works just like the Freezer process. Press the Fridge button to set your desired temperature. After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display. Recommend Temp (Fridge) : 38°F (or 3°C ) - The temperature of the Freezer, Fridge or Pantry Room may rise when you open the doors too frequently, or if a large amount of warm or hot food is placed inside. - This may cause the digital display to blink. Once the freezer and Fridge temperature return to their normal set temperatures, the blinking will stop. - If the blinking continues, you may need to "reset" the refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in. - If there is a communication error between the Display and Main Controller, the Pantry Display light may blink. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center. USING THE COLD WATER DISPENSER Push the appropriate ice type button to select what you want dispensed. NO ICE Select this if you want to turn ice maker off Using the ice Dispenser Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass. Make sure the glass is in line with the dispenser to prevent the ice from bouncing out. Please wait 2 seconds before caution removing the glass under the dispenser to prevent spills. If the Refrigerator door opens, the Dispenser does not work. When Cubed Ice is selected after using the caution Crushed Ice mode, a small amount of residual crushed ice might be produced. Do not pull the lever out. You could damage caution or break the lever's spring. • To clean the ice bin/ bucket, wash with a mild detergent, rinse well, and dry thoroughly check the water level it. Do not use harsh or abrasive cleaners or solvents. • When you select Cubed Ice after using Test button the Crushed Ice mode, a small amount of residual crushed ice might be produced. • If ice doesn't come out, pull out the ice bucket and press the test button located on the right side of ice maker. • Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice may jam the bucket. • Normal Use To fill the ice bucket to maximum capacity after installation, follow these steps: 1. Allow your refrigerator to operate and cool down for 24 hours (or 1 full day). - Waiting 24 hours will allow your ice maker to cool properly. 14_ operating