Samsung RS25J500DSR User Manual - Page 31
Installing the water dispenser line - water filter
View all Samsung RS25J500DSR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Setting up Wrench 3 2 Bolt 1 Nut 3. After adjusting the doors, turn the nut (1) clockwise ( ) until it reaches the lower end of the bolt, then tighten the bolt again with the wrench (3) to fix the nut in place (1). NOTE • If you do not secure the nut firmly, the bolt may release. Installing the water dispenser line A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. The water line also connects to the ice maker. For the ice maker to operate properly, water pressure of 20 ~ 125 psi (138 ~ 862 kPa) is required. If the refrigerator is installed in an area with low water pressure (below 20 psi), you can install a booster pump to compensate for the low pressure. After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until water runs from the water dispenser. NOTE • Water line installation kits are available at extra cost from your dealer. We recommend using a water supply kit that contains copper tubing. DA68-02981N-00.indb 31 English 31 2015. 3. 3. 9:34