Samsung WA476DSHASU/A1 Trouble Shooting Guide User Manual Ver.1.0 (English, Fr - Page 2
Alignment And Adjustments
View all Samsung WA476DSHASU/A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. GENERAL ERROR FUNCTION Error Code NO (Diagnostic Code Error Image) Description Corrective Action 1 nd The water level fails to drop below the Go to " Will Not Drain" Troubleshooting Reset Water Level within 30 minutes. Section. 2 LO Door fails to Unlock After 7 attempts. Go to " Will Not Unlock" Troubleshooting Section. 3 nF When the filling Continues for more than 60 minutes or there is no change of water level for 6 minutes. Go to " No Water Fill" Troubleshooting Section. 4 FL Door fails to lock after 7 attempts. Go to " Will Not Lock"Troubleshooting Section. 5 LE A water level lower than the Reset water level is detected for 5 seconds during the Wash/Rinse cycle. Go to "No Water Fill" Troubleshooting Section. Water Level Sensor Trouble. (When 6 1E the input signal from the water level sensor is out of range, the unit will send out beeping sounds and halts Go to "No Water Fill" Troubleshooting Section the cycle.) A fault is detected in the water level sensor. Data (frequency) shows the 7 OE water level is at or above the overflow water level. (When this condition is detected, the machine will automatically starts draining water First check to see that all of water valves are not stuck. If water valves are OK, check water level. until the water level falls below the reset water level) 8 dc Unbalance or cabinet bump is detected during final spin Go to "Wet Clothes"Troubleshooting Section. Jammed Key.(When key input signals Check all of keys. If A key is sensed 9 E2 are coming out for more than 30 to be pressed, all keys will do not seconds, it is regarded as a jam.) respond. 10 ds Door is detected as open while it is Go to "Quick Test Mode" and then do trying to lock the door. Door Lock/Unlock Test 2 [Technical information]WA484DSHA_03051B_EN.indd 2 2012-06-25 �� 11:11:58