Sanyo VCC-XZ600N Installation Manual - Page 2

Information To User Be sure to observe the following • Be extremely careful when carrying out work such as drilling holes in order to install this camera. In addition, pull out cables such as the power cable and video cable so that they can be easily routed. • When installing the camera, take proper steps to ensure that the ceiling or wall is waterproof. • Select a ceiling or wall surface which is flat and durable and which can support the full weight of the camera. If installing to a curved surface or a round pole or similar, use a commercially-available mounting bracket to install the camera. • Install the camera in a place where the ambient temperature (with power source connected) is within -20°C - 50°C/-4°F +122°F. (Condensation should not form.) • If direct sunlight will shine onto the camera, install the accessory sunshade. Precautions ■ In case of a problem Do not use the unit if smoke or a strange odor comes from the unit, or if it seems not to function correctly. Turn off the power immediately and disconnect the power cord, and then consult your dealer or an Authorized Sanyo Service Center. ■ Do not open or modify Do not open the cabinet, as it may be dangerous and cause damage to the unit. For repairs, consult your dealer or an Authorized Sanyo Service Center. ■ Do not put objects inside the unit Make sure that no metal objects or flammable substance get inside the unit. If used with a foreign object inside, it could cause a fire, a short-circuit or damage. Be careful to protect the unit from rain, sea water, etc. If water or liquid gets inside the unit, turn off the power immediately and disconnect the power cord, and then consult your dealer or an Authorized Sanyo Service Center. ■ Be careful when handling the unit To prevent damage, do not drop the unit or subject it to strong shock or vibration. ■ Do not install this unit close to magnetic fields The magnetic fields may result in unstable operation. ■ Protect from humidity and dust To prevent damage, do not install the unit where there is greasy smoke or steam, where the humidity may get too high, or where there is a lot of dust. ■ Protect from high temperatures Do not install close to stoves, or other heat sources, such as spotlights, etc., or where it could be subject to direct sunlight, as this could cause deformation, discoloration or other damage. Be careful when installing close to the ceiling, in a kitchen or boiler room, as the temperature may rise to high levels. ■ Cleaning • Dirt can be removed from the cabinet by wiping it with a soft cloth. To remove stains, wipe with a soft cloth moistened with a soft detergent solution and wrung dry, then dry by wiping with a soft cloth. • Do not use benzine, thinner or other chemical products on the cabinet, as this may cause deformation and paint peeling. Before using a chemical cloth, make sure to read all accompanying instructions. Make sure that no plastic or rubber material comes into contact with the cabinet for a long period of time, as this may cause damage or paint peeling. ■ Approvals: IP66/CE This unit has been certified to IP66 standards when properly installed. Use only an IP66 certified enclosure or an electrical box. Ensure all openings in enclosure are sealed as per manufacturer's instructions. 1