Sanyo VPC HD1 Instruction Manual, VPC-HD1A - Page 39
PREPARING THE REMOTE CONTROL UNIT, Changing the remote control code
UPC - 086483059766
View all Sanyo VPC HD1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
PREPARING THE REMOTE CONTROL UNIT Changing the remote control code The remote control unit will also work with other Sanyo cameras that can be operated by infrared remote control. When more than one camera is present, it is recommended to change the remote control code to ensure that only the intended camera operates when the remote control unit is used. The remote control code is set to "RC CODE 1" at the time of purchase. 1 Aim the infrared emitter at the remote control sensor on the docking station. 2 Hold down the CH button and press the [J] button for about 3 seconds. 3 Press a button on the remote control unit and check that the camera is receiving correctly. h The remote control codes are retained even if the batteries in the remote control unit or camera are replaced. h If the remote control codes for the remote control unit and the camera and do not match, the remote control unit cannot be used to operate the camera. 1 Aim the infrared emitter at the remote control sensor on the docking station. 2 Hold down the CH button and press the [I] button for about 3 seconds. 25 English