Sanyo WXE45 User Manual - Page 45

Setting Standby mode This function is available when operating the projector via network. Normal........ Supply the power to the network function even after turning off the projector. You can turn on off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off. Eco Select "Eco" when you do not use the projector via network. The projector's network function will stop when turning off the projector. Refer to the owner's manual "Network Set-up and Operation". Power management For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the input signal is interrupted and no button is pressed for a certain period. When the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with "No signal" appears. The countdown starts to turn off the lamp. Select one of the operations. Ready.........When the lamp has been fully cooled down, the POWER indicator changes to green blinking. In this condition, the projection lamp is turned on if the input signal is reconnected or any button on the remote control is pressed. Shut down...When the lamp has been fully cooled down, the power is turned off. Off P ower management function is off. Then set the countdown timer with the Point ◄► buttons. Note: Factory default is "Ready: 5 min." Power management Time left before Lamp is off. Press the SELECT button at Power management and this box appears. Select one of three settings with the Point ◄► buttons, and go to the timer with the Point ▲▼ buttons and set time with the Point ◄► buttons. 45