Sharp AR-M208 AR-M208 Key Operator's Guide - Page 12
Erase Adjust, Stream Feeding, Rotation Copy
View all Sharp AR-M208 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
KEY OPERATOR PROGRAMS Erase Adjust Set the initial setting of the amount of the erase area with this program. When "ERASE ADJUST" is selected and the OK key is pressed, the following display will appear. ERASE ADJUST 1/4 inch (1/4~1) 1. Adjust the value for the edge erase mode and center erase mode using the and keys. G The value can be set from 1/4" to 1" in 1/4" increments. 2. Press the OK key. Stream Feeding This program is used to enable the stream feeding mode of a RSPF. When the stream feeding mode is enabled, additional originals which are set in the document feeder tray within 5 seconds after the previous original was fed will be fed and copied automatically. To enable the stream feeding mode, highlight "STREAM FEEDING" and press the OK key to display a check mark in the check box. To disable this function, select this program and press the OK key again to clear the check mark in the check box. Rotation Copy If this program is set, the image of originals will rotate when the orientation of the originals does not match that of the copy paper. Rotation copy will function only when the auto paper select or auto image mode has been selected. NOTE: If the image is rotated in reduction copying, the position of the image in relation to copy paper will vary with the orientations of the originals and copy paper. Original Copy paper Copy To enable rotation copy, highlight "ROTATION COPY" and press the OK key to display a check mark in the check box. To disable this mode, select this program and press the OK key again to clear the check mark in the check box. 10