Sharp AR-M208 AR-M208 Key Operator's Guide - Page 16

KEY OPERATOR PROGRAMS Preheat Mode Preheat mode functions to reduce the power consumption by lowering the temperature of the fusing unit to a programmed level once a programmed length of time has elapsed without any copier operation after the last copy of a run is made or power is turned on. The preheat mode will help lower the user's electricity bill, reduce waste of natural resources, and cut down on environmental pollution. The programmed time is set to the factory default of 15 minutes as shipped from the factory. The default time can be changed optionally within the prescribed range of time. We suggest you set the most appropriate time according to your usage pattern. The interval can be set to 1, 2, 5, 10, 15, 30, 60, 120 or 240 minutes. When "PREHEAT MODE" is selected and the OK key is pressed, the following display will appear. PREHEAT MODE 15 min. (1~240) 1. Select the desired time interval using the and keys. 2. Press the OK key. Time Out Setting If a copy job is started while a print or fax job is being run, the print or fax job will be interrupted. This program is used to adjust the time that elapses before the print or fax job resumes after the copy job is completed. If a print or fax job is sent to this machine while a copy job is being run, printing of the print or fax job will start when the programmed time elapses after the copy job is completed. The time can be set to 0, 10, 30 or 60 seconds. If 0 is set, the print or fax job will resume immediately after a copy run has finished. (A facsimile expansion kit must be installed to run a fax job.) When "TIME OUT SETTING" is selected and the OK key is pressed, the following display will appear. TIME OUT SETTING 30 sec. (0~60) 1. Select the desired time using the and keys. 2. Press the OK key. 14