Sharp AR-M208 AR-M208 Key Operator's Guide - Page 17

KEY OPERATOR PROGRAMS ENABLE/DISABLE The programs of this category are used to enable or disable some functions. These programs can be set or canceled by using the and keys to highlight "ENABLE/DISABLE", pressing the OK key, highlighting the desired program, and then pressing the OK key. Disable Auto Paper Selection This program is used to prevent automatic paper selection. When disabled, the copier will not automatically select a paper tray containing paper that matches the size of the original placed on the platen glass or in a RSPF. To disable auto paper selection, highlight "DISABLE AUTO PAPER SELECTION" and press the OK key to display a check mark in the check box. To restore this function, select this program and press the OK key again to clear the check mark in the check box. Disable Auto Tray Switching This program prevents automatic switching between the paper trays. If automatic tray switching is enabled, when paper runs out during copying, any tray with paper of the same size in the same orientation will be automatically selected and copying will continue. To disable auto tray switching, highlight "DISABLE AUTO TRAY SWITCHING" and press the OK key to display a check mark in the check box. To restore this function, select this program and press the OK key again to clear the check mark in the check box. Disable Job Program Changing This program is used to prevent stored programs from being replaced or deleted. If this program is set, storing of job programs is also disabled. To prevent job programs stored in memory from being replaced or deleted, highlight "DISABLE JOB PRG. CHANGING" and press the OK key to display a check mark in the check box. To allow replacement/deletion, select this program and press the OK key again to clear the check mark in the check box. Disable Center Tray Counting In the default setting, when copies or printed sheets are delivered to the center tray of the copier, the number of sheets delivered will be counted. When counting is enabled, the copier will automatically stop when the count has reached the limit. This program can be used to disable counting in the center tray of the copier. To disable counting, highlight "DISABLE CENTER TRAY COUNTING" and press the OK key to display a check mark in the check box. To enable counting, select this program and press the OK key again to clear the check mark in the check box. 15