Sharp CV10NH CV-10NH Operation Manual - Page 12
Install Window Panel
UPC - 074000662377
View all Sharp CV10NH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INSTALL WINDOW PANEL Installation in a double-hung sash window (See page 12 for installation in a sliding sash window. ) 1 Connect the rain guards to the insect guard net. Hole Insert all three projections on each rain Insect guard guard into the holes in the insect guard net. net Side "A" will now be at the top, as indicated in the diagram. Projection Rain guard "A" 2 Attach the guard combined above to the window panel Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel. Side "A" will now be at the top, as indicated "A" in the diagram. Projection Window panel 3 Cut the foam seal A (adhesive type) to the proper length and attach it to the window stool. Foam seal A (adhesive type) 4 Attach the window panel to the window stool. If the inner width of the window is between 22" (559mm) and 24" (609mm) inclusive. The window panel cannot be installed in windows less than 22" (559mm) wide, as you will be unable to shut the exhaust cover. (1) Remove the adjustment panel from the window panel, and cut the window panel to the same width as the window. (2) Open the window sash and place the window panel on the window stool (3) Secure the window panel to the window 22"~ 24" stool with 2 screws. E-10 Cut Window panel Window stool