Sharp CV10NH CV-10NH Operation Manual - Page 14

INSTALL WINDOW PANEL Installation in a sliding sash window (See page 10 for installation in a double-hung window.) 1 Connect the rain guards to the insect guard net. Insert all three projections on each rain guard into the holes in the insect guard net. Side "A" will now be at the top, as indicated in the diagram. Insect guard net Hole Projection 2 Attach the guard combined above to the window panel. Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel. Side "A" will now be at the top, as indicated in the diagram, when it is installed in the window. Projection 3 Cut the foam seal A (adhesive type) to the proper length and attach it to the window frame. 4 Install the window panel into the window frame. If the inner height of the window is between 22" (559mm) and 24" (609mm) inclusive. The window panel cannot be installed in windows less than 22" (559mm) high, as you will be unable to shut the exhaust cover. (1) Remove the adjustment panel from the window panel, and cut the window panel to the same height as the window. (2) Open the window sash and place the window panel on the window frame. (3) Secure the window panel to the window frame with 2 screws. Window panel E-12 "A" Rain guard Window panel "A" Foam seal A (adhesive type) Cut 22"~24"