Sharp DK-CL6N DK-CL6N Operation Manual - Page 11
Alarm and sleep operation
UPC - 074000369412
View all Sharp DK-CL6N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Listening to the radio (continued) Alarm and sleep operation ■ Memorizing a station You can store 10 AM and 10 FM stations in memory and recall them at the push of a button. (Preset tuning) 1 Perform steps 1 - 4 in "Tuning" on page 10. 2 Press the EQUALIZER/-PROG button for more than 2 seconds on the main unit or remote control (DK-CL6N only) to enter the preset tuning saving mode. ■ Alarm The unit turns on and play desired source (iPod or TUNER) or Buzzer sound for 1 hour alarm cycle. Before setting the alarm: 1 Check that the clock is set to the correct time. (refer page 8) If it is not set, you cannot use the alarm function. 2 For iPod playback: Insert iPod to the unit. (refer page 9) 3 For TUNER: Set preset memory. (refer left) 3 Within 1 minute, press the or button to select the preset channel number. Store the stations in memory, in order, starting with preset channel 1. 4 Within 1 minute, press the EQUALIZER/-PROG button on remote control to store that station in memory. Setting the alarms In this example, the setting is for ALARM 1. The same method is used to set for ALARM 2. 1 Press and hold the ALARM 1 button until the alarm time flashing. If the preset number indicators disappear before the station is memorized, repeat the operation from step 2. 5 Repeat steps 1 - 4 to set other stations, or to change a preset station. When a new station is stored in memory, the station previously memorized for that preset channel number will be erased. Note: The backup batteries function protects the memorized stations should there be a power failure or the AC power cord becomes disconnected. If the backup batteries are drain off, the memorized stations will be erased. 2 Press the TUNING/SET ( or ) button to adjust the hour and then press the ALARM 1 button. Press the TUNING/SET ( or ) button once to advance the time by 1 hour. Hold it down to advance continuously. "AM" or "PM" indicator will interchange after each 12 hour cyclic. 3 Press the TUNING/SET ( or ) button to adjust the minutes and then press the ALARM 1 button. MON ■ To recall a memorized station Press the or desired station. button for less than 0.5 seconds to select the Press the TUNING/SET ( or ) button once to advance the time by 1 minute. Hold it down to change the time in 5 minutes interval. 4 Press the TUNING/SET ( or ) button to select the wake up source and then press the ALARM 1 button. Wake up source: BUZZER RADIO iPod Two beeps will indicate alarm setting is complete. Note: If wake up source is set to iPod, and iPod is not present, the alarm source will change to default Buzzer. Caution: During alarm activation, sound will be not output to the speaker if headphones is plugged in. Make sure to unplug the headphones if it is not used. Volume auto fade-in (Alarm mode) ● If turn off the main unit with the volume set to lower than Vol 16, the wake up alarm volume will start at last set level and fades into the Vol 16. ● If turn off the main unit with the volume set to higher than Vol 16, the wake up alarm volume will starts at Vol 16 and fades into the last set level. 11