Sharp ER-A450T Programmer Manual - Page 40

Channel No.: 0 = No connection 1 = Standard port 2 2-7 = Not used 8 = Standard port 1 NOTE: There can be only 2 devices supported by the ECR at any one time. Will ENTRY ERROR is occurred when a device has been set as the same channel that is used by another device. [JOB#2691] BARCODE READER PROGRAMMING 0 2691 @/FOR WXYZ CA/AT W: Data bit W 8 bits 0 7 bits 1 X: Parity bit X Even 0 Odd 1 Non 2 Y: Stop bit Y 2 bits 0 1 bit 1 Z: Transmission speed Z 4800 bps 0 9600 bps 1 19200 bps 2 MRS = 1110(For ER-A6HS1) [Job# 2710] TAX TABLE PROGRAMMING 2710 @/FOR AB @/FOR Declaration of TAX XX.XXXX TAX rate XXXX Cycle @/FOR XXX @/FOR Initial TAX XXXXX @/FOR XXXXX @/FOR Lower TAX limit Break point CA/AT @/FOR 72 BREAKPOINTS CAN BE PROGRAMMED FOR EACH TAXTABLE. (When the interval between break point is 1 dollar or more and less than 100 dollar, 36 breakpoints is programmed for each table.) DEPRESSION OF THE SBTL KEY AT THE FOLLOWING POINTS WILL RESULT IN A TAX TABLE DELETE OPERATION. A: INTERVAL BETWEEN BREAKPOINTS IS = 1 1 DOLLAR OR MORE AND LESS THAN 100 DOLLAR INTERVAL BETWEEN BREAKPOINTS IS = 0 BELOW 1 DOLLAR B: TABLE 1 PROGRAMMING = 1 TABLE 2 PROGRAMMING = 2 TABLE 3 PROGRAMMING = 3 TABLE 4 PROGRAMMING = 4 TAX RATE CYCLE INITIAL TAX LOWER TAX LIMIT BREAK POINT MRS = NO TAX : 0.0000 - 99.9999 : 0 - 9999 : 0 - 999 : 0 - 99999 : 0 - 99999 [JOB#2711] TAX RATE PROGRAMMING 2711 @/FOR A @/FOR Declaration of TAX XXX.XXXX @/FOR TAX rate CA/AT When lower tax limit is 0. XXXXX CA/AT Lower tax limit for add tax. DEPRESSION OF THE ST KEY AT FOLLOWING POINTS WILL RESULT IN A TAX TABLE DELETE OPERATION. A: Tax programming A Tax1 1 Tax2 2 Tax3 3 Tax4 4 xxx.xxxx: % TAX rate = 0.0000-999.9999% LOWER TAX LIMITATION = 0.00 to 999.99 (This is invalid in VAT system.) MRS = 0 [JOB#2715] QUANTITY FOR DOUGHNUT EXEMPT ( For Canadian TAX ) 0 2715 @/FOR XX CA/AT XX: Quantity for doughnut TAX exempt = 0 - 99 MRS = 0 [JOB#2810] PBLU code ( The range programming of available PBLU codes) 0 2810 @/FOR XXXX @/FOR YYYY CA/AT XXXX:Start code = 1 - 9999 YYYY:End code = 1 - 9999 MRS = 0001(Start code) / 9999(End code)