Sharp LC-60LE810UN Service Manual - Page 42

LC-40/46/52/60LE810UN (1st Edition) Page 23 24 Line 1 2 3 4 5 6 1 2 3 4 5 6 7 8 9 10 Item ERROR STANDBY CAUSE1 ERROR STANDBY CAUSE2 ERROR STANDBY CAUSE3 ERROR STANDBY CAUSE4 ERROR STANDBY CAUSE5 ERROR STANDBY CAUSE RESET EEP SAVE EEP RECOVER MODL NAME PANEL SIZE SETTING FOR ADJ PANEL LIMIT PANEL RANGE LIMIT SHORT CHECK MODE SHORT CHECK CURRENT CURRENT SW Description Writing setting values to EEPROM Reading setting values from EEPROM Remarks (adjustment detail, etc.) *1 Details of P1.9 (NORMAL STANDBY CAUSE) 2 No operation off 3 No signal off 4 PC power management mode 1 5 PC power management mode 2 6 Off timer 8 Command from RS232C in the cause of "no operation off" in the cause of "no signal off" in the cause of "Standby mode MODE1" in the cause of "Standby mode MODE2" in the cause of "SLEEP timer" in the cause of command by RS-232C *2 Details of P1.10 (ERROR STANDBY CAUSE) 11 Prolonged unspecified-signal input in PC mode 17 Temperature error 1A Monitor trouble detected 22 LCD controller Rom error in the cause of continuous "out of range", PC input mode in the cause of abnormal temperature in the cause of abnormal monitor mode in the cause of software abnormality of LCD controller 6. Special features * STANDBY CAUSE (Page 1/24) Display of a cause (code) of the last standby The cause of the last standby is recorded in EEPROM whenever possible. Checking this code will be useful in finding a problem when you repair the troubled set. * EEP SAVE (Page 24/24) Storage of EEP adjustment value * EEP RECOVER (Page 24/24) Retrieval of EEP adjustment value from storage area 5 - 8