Sharp PN-E471 PN-E421 PN-E471 Operation Manual - Page 11
Audio, Setup, Menu Items, Option Dc Out Setting
UPC - 074000046955
View all Sharp PN-E471 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Menu Items nAUDIO TREBLE Adjusts the volume of treble-level sound. BASS Adjusts the volume of bass-level sound. BALANCE Adjusts the balance of the audio sound between right and left. RESET Resets the values of the AUDIO menu items to the factory preset values. Select "ON" and then press . nSETUP OSD H-POSITION Adjusts the horizontal display position of menu screen. OSD V-POSITION Adjusts the vertical display position of menu screen. MONITOR (for PN-E421 only) Select the installation direction of the monitor. LANDSCAPE............Horizontal orientation PORTRAIT Vertical orientation MONAURAL AUDIO Outputs audio signals as monaural. LANGUAGE Sets the display language for the menu screen. POWER ON DELAY You can delay the screen display after the monitor is turned on. The period can be set up to 60 seconds in units of one second. When this function is activated, the power LED flashes (at approx. 1 second interval) in orange. This function is disabled when 0 is specified. STANDBY MODE When STANDARD is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed in standby mode. When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the startup time from standby mode becomes longer. Also, certain RS-232C commands cannot be used in standby mode, and control via LAN will be disabled. (See pages 22 and 29.) HDMI SETTING HDMI AUTO VIEW When ON is selected, the screen size is adjusted automatically according to the screen size control signal included in the video signal input from the AV HDMI input terminal. HDMI RGB INPUT RANGE Sets the type of HDMI signals when using the AV HDMI input mode. When AUTO is selected, the type is set automatically. HOT PLUG CONTROL Sets whether to use hot plug control for the PC/AV HDMI and PC/AV DVI-D input terminals. RS-232C/LAN SELECT Selects the method with which to control the monitor from the computer. ID No. SET Assigns ID numbers to monitors connected in a daisy chain (see page 19), using RS-232 cables. The numbers 1 to 255 are available for ID numbers. If "0" is set, the system regards this as the state where no ID number is set. BAUD RATE Selects the communication speed used for RS-232C communication. LAN SETUP Configures the settings to control the monitor from the computer via LAN. (See page 29.) SPEAKER SELECT Selects the speaker to be used. OPTION DC OUT SETTING Normally, leave this setting as OFF. When using an optional part, if instruction appears, change the setting accordingly. 11 E