Sharp PN-E471 PN-E421 PN-E471 Operation Manual - Page 12

Menu Items nOPTION DATE/TIME SETTING Set the date and time. Press or to select the date and time, and press or to change the numerical values. Set the date in "Year/Month/Day" order. Set the time on a 24-hour basis. SCHEDULE (See page 15.) You can set the time to switch the monitor on and off. INPUT SELECT Select the input mode to be used in PC/AV DVI-D input terminal, PC/AV HDMI input terminal and PC RGB/AV component input terminals. AUDIO SELECT Selects the terminal used to input audio signals in each input mode. INPUT SIGNAL (PC D-SUB/PC RGB) If a computer connected to the PC D-sub/PC RGB input terminal outputs any of the following resolutions, make a selection from the following options. 480 LINES...........AUTO, 640x480 or 848x480 768 LINES...........AUTO, 1024x768, 1280x768, or 1360x768 1050 LINES.........1400x1050 or 1680x1050 ZOOM2 SPECIAL SETTING (See page 14.) SCAN MODE (AV input) Sets the scan mode used for AV mode input. MODE1 Over-scan display MODE2 Under-scan display MODE3 Under-scan display when the input signal is 1080i/p. Otherwise, over-scan display * E ven when MODE1 is selected, under-scan display is used when the input signal is 1080i/p and the screen size is Dot by Dot. POWER MANAGEMENT POWER MANAGEMENT determines whether or not to switch modes from no signal to the input signal standby mode. COLOR SYSTEM (AV S-VIDEO/AV VIDEO) Select the color system of the AV equipment which is connected to AV S-video and AV video input terminal. (AUTO / PAL / PAL-60 / SECAM / NTSC3.58 / NTSC4.43) When AUTO is selected, the color system is automatically set according to the input signal. AUDIO OUTPUT Sets the volume of sound output from the audio output terminals. VARIABLE...........You can adjust the volume using VOLUME. FIXED Fixes the sounds. AUDIO INPUT LEVEL Selects the maximum audio input level of the audio input terminal. SELF ADJUST On a PC D-SUB/PC RGB screen, specify whether to perform screen adjustment automatically or not. When ON is selected, the screen is automatically adjusted when its resolution is 800 x 600 or higher and the timing of input signals changes. "ADJUSTING" appears on the screen during the adjustment. Depending on the signal, adjustment may not be possible. In this case select OFF. (Perform manual adjustment of the screen.) AUTO INPUT CHANGE Specify whether to change inputs automatically. When ON is selected and no signal is present in the selected input mode, AUTO INPUT CHANGE automatically changes the selected mode to another mode where a video signal is present. When video signals exist in multiple input modes, the switching priority is as follows: PC D-SUB, PC HDMI and AV HDMI When the PN-ZB01 (optional) is attached: PC DVI-D, PC HDMI, PC D-SUB, PC RGB, AV DVI-D, AV HDMI, AV COMPONENT, AV S-VIDEO and AV VIDEO (Input mode switching may take 15 seconds or more, depending on the connected equipment. Input signals may not be detected properly and a priority may change, depending on the connected equipment or video signals.) nENLARGE (PC input) ENLARGE H Sets the number of screen splits (number of monitors) in the horizontal direction used for the enlargement. (See page 14.) ENLARGE V Sets the number of screen splits (number of monitors) in the vertical direction used for the enlargement. (See page 14.) ENLARGE-POS H / ENLARGE-POS V Specify the split screen to be displayed when the enlargement function is used. (See page 14.) BEZEL H / BEZEL V Sets the frame width of the display when the enlargement function is used. H-POS Adjust the horizontal position of the enlarged screen. V-POS Adjust the vertical position of the enlarged screen. E 12