Sharp PN-E471 PN-E421 PN-E471 Operation Manual - Page 17

Initialization (Reset)/Functional Restriction Setting (FUNCTION) You can return the settings to their factory-preset values and restrict operations. 1. After pressing for about 5 seconds, press , , , and in that order. FUNCTION 1/1 ALL RESET ADJUSTMENT LOCK RS-232C OSD DISPLAY LED TEMPERATURE ALERT STATUS ALERT POWER BUTTON CONTROLLER INPUT OFF UNLOCKED ON ON LED OFF MONITOR END...[MENU] 2. Select and set the items. ALL RESET Resets the settings to the factory default settings. Press , select ALL RESET, and then press . After initialization, turn the main power switch off and then back on. When the PN-ZB01 (optional) is attached, press , select the resetting method, and then press . ALL RESET1.....Resets all the settings to the factory default settings. ALL RESET2.....Returns all settings to the factory default settings except for the following items: LAN SETUP, RS-232C/LAN SELECT, ID No. SET, BAUD RATE, NETWORK, MAIL, SERVICE & SUPPORT, and SNMP (See page 11, and pages 33 to 36.) ADJUSTMENT LOCK You can disable operations on the monitor and the remote control unit that use buttons. OFF....Enables operation. 1.........Disables all operations other than turning power on/off and FUNCTION. 2.........Only the FUNCTION operation is enabled. Disables all operations other than FUNCTION (not even power on/off). RS-232C (RS-232C/LAN when the PN-ZB01 (optional) is attached) Specifies whether to allow control via RS-232C or LAN (see pages 18 and 29). OSD DISPLAY Hides/shows menus. The FUNCTION screen cannot be hidden. LED Specifies whether to light the power LED. OFF cannot be selected when STANDBY MODE is LOW POWER. TEMPERATURE ALERT Selects the notification method for an abnormal temperature. OFF Do not notify about an abnormal temperature. OSD & LED... When an abnormal temperature is detected, the power LED flashes in red and green alternately and the screen displays a message: TEMPERATURE. LED When an abnormal temperature is detected, the power LED flashes in red and green alternately. STATUS ALERT Selects the notification method for a hardware error. OFF Do not notify about the error. OSD & LED... When a hardware error is detected, the power LED flashes in red and the screen displays a message: STATUS [xxxx]. LED When a hardware error is detected, the power LED flashes in red. POWER BUTTON Normally, leave this setting as MONITOR. When using an optional part, if instruction appears, change the setting accordingly. CONTROLLER INPUT Normally, you do not need to change this setting. When using an optional part, if instruction appears, change the setting accordingly. 3. Press to return to the normal screen. TIPS • When both abnormal temperature and hardware error are detected, the hardware error notification overrides. 17 E