Sharp TL-M4600 TL-M4600 , TL-M5200 Operation Manual - Page 40
Standby Mode, DHCP Client - power consumption
UPC - 074000365643
View all Sharp TL-M4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Menu operations Adjusting the computer image manually Ordinarily you can easily adjust the picture as necessary to change image position using "Auto Sync". In some cases, however, manual adjustment is needed to optimize the image. Selectable items Description H-Position Centers the image by moving it to the left or right. V-Position Centers the image by moving it up or down. Clock Adjusts when the image flickers with vertical stripes. Phase Adjusts when characters have low contrast or when the image flickers. Note • If "H-Position" and "V-Position" in "Fine Sync" are set, "H-Position" and "V-Position" in "Position" become invalid. • For resetting all adjustment items to the factory preset values, press ▲/▼ to select "Reset", press ENTER, press ▲/▼ to select "Yes", and then press ENTER. • Images may not be displayed properly depending on the settings and/or input signals. n Reducing the start-up time (Standby Mode) You can reduce the monitor's start-up time after turning on the power with the remote control. Selectable items Description Mode1 Starting the monitor is quick from standby. Mode2 The RS-232C and Network functions are activated even if the monitor is in the standby mode. Mode3 Power consumption is low while in standby mode. The RS-232C and Network functions are switched off in standby mode. n Auto restart function (Auto Restart) Selectable items Description On If the power cord is unplugged from the outlet or the breaker switch is turned off when the monitor is on, then the monitor automatically turns on when the power cord is plugged into the AC outlet or the breaker switch is turned on. Off The monitor does not turn on automatically when the power cord is plugged into the AC outlet or the breaker switch is turned on. n Selecting the transmission speed (RS-232C) Make sure that both the monitor and computer are set for the same baud rate. Selectable items Description 9600bps Transmission speed is slow. 115200bps Transmission speed is rapid. n DHCP client setting (DHCP Client) Connect the LAN cable before turning the monitor on. If not, the DHCP Client function does not work. Selectable items Description On Obtains configuration parameters for TCP/IP network automatically. Off Sets the TCP/IP manually. Select "On" for "DHCP Client". "Obtaining IP Address..." appears, then the menu screen appears. Confirm the parameters of IP Address, Subnet Mask and Gateway on the TCP/IP screen. If the DHCP server is not available, "Could not obtain IP Address." appears. In this case, set the TCP/IP manually. (See page 39.) 38