Snapper RE110 Operater's Manual - Page 21

Maintenance ! WARNING ! DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap must be closed securely to prevent fuel spillage. Mower Deck Linkage - Lubrication Lubricate all mower deck linkage pivot points with a light coat of motor oil. A Mower Deck Levelness Check the mower deck for proper level. Adjust as required. Refer to the section entitled "MOWER DECK ADJUSTMENT - LEVELNESS". Clean Mower Deck Figure 24: Mower blade spindle grease fitting 1. Follow the WARNING statement found on this page. 2. Carefully stand the Rear Engine Rider on the rear Front Wheel Bearing - Lubrication bumper. (See statement below.) 4. Clean the underside of the mower deck, removing all accumulation of grass clippings and debris. r n 5. Clean the top of the deck, removing all grass clippings fo tio and debris. Mower Blade Spindle - Lubrication t c 1. Follow the WARNING statement found on this page. 2. Carefully stand the Rear Engine Rider on the rear o u bumper. (See statement below.) 3. Lubricate the spindle grease fitting (A, Figure 24) with N d three shots of general purpose grease from a grease gun. ro IMPORTANT: If the unit will be on its rear bumper for longer p than two hours, remove the battery. Refer to the Section entitled "BATTERY REMOVAL". Re IMPORTANT Lubricate the front wheel grease fittings (A, Figure 25) with five shots of general purpose grease, from a grease gun. A Figure 25: Front wheel grease fitting Shift Lever - Lubrication Lubricate the shift lever grease fitting (A, Figure 26) with two shots of general purpose grease from a grease gun. To avoid damaging the emissions system: • Do not overfill the fuel tank. Stop filling the tank when fuel collects in the filler neck. • Empty the fuel tank before standing the machine on its rear bumper. A Figure 26: Shift lever grease fitting 21