Snapper RE110 Operater's Manual - Page 26

Maintenance ! WARNING ! DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap must be closed securely to prevent fuel spillage. B A Mower Drive Belt Adjustment (For 28" & 30" Decks Only) 1. Remove the mower drive belt cover. Refer to the section entitled "CHECK MOWER DRIVE BELT". Figure 36: Mower belt adjustment 2. Move the blade lever up and over to the "ON" position. 3. Place the deck cutting height lever in the third position (middle notch). Measure the belt spacing (B, Figure 35) between the idler pulley (A) and belt. The distance should measure 1-1/4" but no less than 1". r n B Not foductio A ro Figure 35: Measuring the belt spacing p 4. If the distance is less than 1", adjust belt tension: e Move the blade lever to the "OFF" position. Loosen the hardware (A, Figure 36) that secures R the clamp that anchors the front frame assembly 5. When belt adjustment is complete, it will be necessary to check Clutch/Brake Cable slack. Disengage the parking brake and allow the pedal (A, Figure 37) to remain in the engaged wheel drive (Up) position. The clutch/brake cable should have approximately 3/16" of slack. If the cable does not have slack adjustment of cable must be performed: Peel back the rubber clutch/brake pedal pad and push one ferrule (B) through the hole (C) in the pedal to attain slack in the cable. Recheck the cable for the approximate 3/16" of slack. Replace the pedal pad when adjustment is complete. IMPORTANT: Too much slack may cause improper clutching, and braking could be affected. Too little slack may cause improper clutch function. Recheck the service brake/park brake and readjust if necessary. Refer to the section entitled "SERVICE BRAKE/PARK BRAKE ADJUSTMENT". C (B) to the rear main case. Pull the front frame forward until the belt spacing, with the blade lever "ON", measures 1-1/4". B Retighten the hardware that secures the clamp. Make sure the hardware is tightened securely. IMPORTANT: The SNAPPER Rear Engine Rider Models with 33" decks do not require belt tension adjustment. But, if the A front frame assembly clamp is loosened for any reason, recheck the belt spacing between the idler pulley and belt. With the blade lever in the "ON" position, the distance should measure 1-3/4". Figure 37: Clutch/brake cable adjustment 26 www.snapper.com