Sony BVME171 Operation Guide - Page 59
Selecting Display Mode, Selecting the Native Scan/Scan Mode
View all Sony BVME171 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Submenu [ALM Hold Reset] Setting When the item is selected, the peak hold of the audio level meter is canceled. [Time Code] Note The [ALM Hold Reset] is not selected in the following cases: When [Format] of the [Channel Configuration] menu is set to [Composite] or [HDMI] When [Audio Level Meter] is set to [Off ] When [Peak Hold] is set to [Off] or [Auto] in the [Audio Level Meter] menu of the [On Screen Set] menu of the [System Configuration] menu Sets whether or not to display the time code ([Off] or [On]). Selecting Display Mode This monitor applies high-contrast to the picture and reproduces accurate color by displaying the interlace signal in progressive mode by the I/P conversion or the PsF·progressive signal in progressive mode without the I/P conversion. You can select interlace display mode according to the input signal or the object to evaluate the picture. Interlace display mode: The picture is displayed in interlace mode without I/P conversion processing. The picture near the original quality of the input signal is monitored. Notes When a 1080/24 1) P (PsF) or 1080/25P (PsF) input signal is displayed in progressive mode, the frame rate for display is 48 1) Hz or 50 Hz to obtain flickerless display. When the input signal is 1080/24 1) PsF or 1080/25PsF and [1080I] is set in the [1080I/PsF] menu of the [Channel Configuration] menu, the frame rate for display is 48 1) Hz or 50 Hz. When selecting the interlace display mode, the luminance is reduced by half in the HDR display. On this monitor, the normal luminance is set by increasing the value of the gain in settings other than the HDR display. For this reason, in the interlace display mode, the range of the contrast adjustment is different from the normal level, and the luminance may be reduced according to the setting of the contrast. The picture is not displayed in interlace mode in the following cases: - When [Side by Side], [Wipe], [Butterfly], or [Blending] is set to [On] - When [Pixel Zoom] is set to on 1 For selecting the interlace display mode, set [Native Scan] (page 55) to [On] in the [Function Setting] menu or by pressing the NATIVE SCAN button of the controller. 2 Set [Interlace] to [On] in the [Function Switch] menu (page 55) of the [Function Setting] menu, or pressing the INTERLACE button on the controller. For the input signal to display in frame mode and interlace mode, see "Picture Frame Display" on page 97. 1) Also compatible with a frame rate of 1/1.001. Selecting the Native Scan/Scan Mode You can select scan mode from a native scan, under scan (-3%), normal scan (0%), and over scan (mask of 5% over scan portion in the normal scan picture). You can set scan mode with the NATIVE SCAN button or Scan button of the controller, or in the [Function Switch] menu of the [Function Setting] menu. Setting with the NATIVE SCAN button or SCAN button of the controller To set to the native scan mode Set the NATIVE SCAN button to on. (The LED on the button lights.) To select the scan mode 1 Set the NATIVE SCAN button to off. (The LED on the button is turned off.) 2 Press the Scan button1) to select the scan mode. Scan mode is changed to normal, under, and over scan mode by each press of the button. 1) Scan function is assigned to a function button of the controller in the [Function Key] menu of the [Controller] menu (page 71). Setting in the menu Set [Scan Mode] or [Native Scan] in the [Function Switch] menu (page 55) of the [Function Setting] menu. 59 Adjustment Using the Menus