Sony CDP-CE535 Operating Instructions - Page 28

Additional Information Troubleshooting If you experience any of the following difficulties while using the player, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. There's no sound. /Check that the player is connected securely. /Make sure you operate the amplifier correctly. /Adjust the output level using the LINE OUT LEVEL +/- buttons on the remote. The CD does not play. /There's no CD inside the player ("-NO DISC-" appears). Insert a CD. /Place the CD with the label side up on the disc tray correctly. /Clean the CD (see page 27). /Moisture has condensed inside the player. Remove the disc and leave the player turned on for about an hour (see page 27). /Place the CD in the correct position on the disc tray. The remote does not function. /Remove the obstacles in the path of the remote and the player. /Point the remote at the remote sensor g on the player. /Replace all the batteries in the remote with new ones if they are weak. /Set the CD 1/2/3 switch on the remote according to the position of the COMMAND MODE selector at the rear panel of the player. The player functions incorrectly. /The microcomputer chips may be operating incorrectly. Turn the power off, then turn it back on to reset the player. Specifications Compact disc player Laser Laser output Frequency response Signal-to-noise ratio Dynamic range Harmonic distortion Channel separation Semiconductor laser (λ = 780 nm) Emission duration: continuous Max 44.6 µW* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up block with 7 mm aperture. 2 Hz to 20 kHz ±0.5 dB More than 107 dB More than 98 dB Less than 0.0040% More than 100 dB Output Jack Maximum type output level Load impedance LINE OUT Phono jacks 2 V Over 10 kilohms (at 50 kilohms) DIGITAL OUT Optical -18 dBm (OPTICAL) output connector Wave length: 660 nm PHONES Stereo 10 mW phone jack 32 ohms General Power requirements Where purchased USA Australia Power requirements 120 V AC, 60 Hz 240 V AC, 50/60 Hz Power consumption Dimensions (approx.) (w/h/d) Mass (approx.) 14 W 430 × 120 × 393 mm (17 × 4 3/4 × 15 1/2 in.) incl. projecting parts 5.4 kg (11 lbs 15 oz) Supplied accessories Audio cord (2 phono plugs - 2 phono plugs) (1) Remote commander (remote) (1) Size AA (R6) batteries (2) Design and specifications are subject to change without notice. 28