Sony MZ-R700 Digital PCLink Operating Instructions - Page 5

4 Windows 98 should already have the various USB components installed and will automatically default to the location of those drivers on your hard drive. Click Next. If Windows 98 does not have the various USB components loaded, it will tell you that the files could not be found and will request the Windows 98 CD. In this case, put your Windows 98 CD into the CD-ROM drive and place a check next to CD-ROM drive, then click Next. 5 The Wizard will now let you know it has located drivers for a USB Composite Device, USB Human Interface Device, or USB Audio Device and will identify these drivers under the heading Location of Driver. This location may be your hard drive, or CD-ROM drive, depending on what drivers your system has had installed in the past. Click Next. 6 The first set of drivers will now install. 7 Once the first set of drivers finishes installing, Windows 98 may require the other two USB drivers to also be installed. This will depend on what USB audio devices have previously been used on your system. Simply follow the procedure outlined above until all the required USB drivers have been loaded. 8 Once all of the required drivers have been installed, Windows 98 will start. We recommend rebooting your computer to ensure all changes take effect. 9 Your driver installation for the Digital PCLink is now complete. Windows Me installation 1 There is no need to turn your computer off when plugging the Digital PCLink in for the first time. Locate your computer's USB port and plug the supplied USB cable in. Now plug the Digital PCLink into the other end of the USB cable. 2 Windows Me will open a New Hardware Found window and let you know it is found the Digital PCLink. It will then start loading drivers for a USB Composite Device, USB Human Interface Device, or USB Audio Device, depending on what components have previously been installed on your system. Click Next. continued 5