Sony PS-LX300USB Operating Instructions - Page 6
To remove the dust cover, Carefully place the platter on the, spindle., Using the ribbon - belt installation
UPC - 027242731271
View all Sony PS-LX300USB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2 Carefully place the platter on the spindle. To remove the dust cover With the dust cover fully opened, grasp both sides of the cover, then remove it carefully. Hinge pocket Hinge 3 Using the ribbon, loop the drive belt around the motor pulley. After looping the belt, do not forget to remove the ribbon. Tip You can use the turntable leaving the dust cover removed. In that case, store the cover correctly. To install the dust cover Insert the hinge pockets on the dust cover into the hinges on the rear of the cabinet. 4 Place the rubber mat on the platter. Note When the AC power cord is plugged after assembling or moving the turntable, the turntable sometimes rotates and the tone arm descends to the platter even if START is not pressed. If this occurs, press STOP to return the tone arm to the arm stand. GB