Sony STRDG820 Operating Instructions - Page 104
Specifications, AUDIO POWER - reset
UPC - 027242727465
View all Sony STRDG820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 8 ohm loads, both channels driven, from 20 Hz - 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Power Output1) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 100 W + 100 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 0.7%) 110 W + 110 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 150 W per channel 1)Measured under the following conditions: 120 V AC, 60 Hz 2)Reference power output for front, center, surround and surround back speakers. Depending on the sound field settings and the source, there may be no sound output. Frequency response Analog 10 Hz - 70 kHz, +0.5/-2 dB (with sound field and equalizer bypassed) Input Analog Sensitivity: 500 mV/ 50 kohms S/N3): 96 dB (A, 500 mV4)) Digital (Coaxial) Impedance: 75 ohms S/N: 100 dB (A, 20 kHz LPF) Digital (Optical) S/N: 100 dB (A, 20 kHz LPF) Output (analog) AUDIO OUT SUBWOOFER Equalizer Gain levels Voltage: 500 mV/ 10 kohms Voltage: 2 V/1 kohm ±10 dB, 1 dB step 3)INPUT SHORT (with sound field and equalizer bypassed). 4)Weighted network, input level. FM tuner section Tuning range 87.5 MHz - 108.0 MHz Antenna (aerial) FM wire antenna (aerial) Antenna (aerial) terminals 75 ohms, unbalanced Intermediate frequency 10.7 MHz AM tuner section Tuning range With 10-kHz tuning scale: 530 kHz - 1,710 kHz5) With 9-kHz tuning scale: 531 kHz - 1,710 kHz5) Antenna (aerial) Loop antenna Intermediate frequency 450 kHz 5)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down TUNING MODE, press POWER on the receiver. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure. Video section Inputs/Outputs Video: 1 Vp-p, 75 ohms COMPONENT VIDEO: Y: 1 Vp-p, 75 ohms PB/CB: 0.7 Vp-p, 75 ohms PR/CR: 0.7 Vp-p, 75 ohms 80 MHz HD Pass Through 104US