Sony STRDG820 Operating Instructions - Page 30

Inserting batteries into the remote Insert two R6 (size-AA) batteries in the RM-AAP021 Remote Commander. Observe the correct polarity when installing batteries. Notes • Do not leave the remote in an extremely hot or humid place. • Do not use a new battery with old ones. • Do not mix manganese batteries and other kinds of batteries. • Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction. • If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. • When you replace the batteries, the programmed remote codes may be cleared. If this happens, program the remote codes again (page 90). Tip Under normal conditions, the batteries should last for about 3 months. When the remote no longer operates the receiver, replace all the batteries with new ones. 7: Selecting the speaker system You can select the front speakers you want to drive. Be sure to use the buttons on the receiver for this operation. SPEAKERS (OFF/A/B/A+B) ON/STANDBY POWER SPEAKERS (OFF/A/B/A+B) TONE MODE TONE TUNING MODE TUNING PHONES VIDEO 2 IN/PORTABLE AV IN VIDEO L AUDIO R AUTO CAL MIC DISPLAY INPUT MODE INPUT SELECTOR MEMORY/ ENTER DIMMER 2CH/ A.DIRECT A.F.D. MOVIE MUSIC MASTER VOLUME Press SPEAKERS (OFF/A/B/A+B) repeatedly to select the front speaker system you want to drive. To select The speakers connected to the SPEAKERS FRONT A terminals The speakers connected to the SPEAKERS FRONT B terminals The speakers connected to both the SPEAKERS FRONT A and B terminals (parallel connection) Light up SP A SP B SP A + B To turn off the speaker output Press SPEAKERS (OFF/A/B/A+B) repeatedly until the "SP A", "SP B" and "SP A+B" indicators on the display do not light up. "ALL OFF" appears on the display for a while. Note You cannot switch the front speaker system by pressing SPEAKERS (OFF/A/B/A+B) when the headphones are connected. 30US