Sony SVR-2000 Setup Guide - Page 13

Getting Started Installing Batteries Before you can use the Remote Control, you must insert the supplied batteries. If you want to use this Remote Control to operate other audio/video equipment, such as a TV or stereo, you must program the Remote Control (see page 51). 1 Pull the latch and lift the cover to open the battery compartment. Notes • When the batteries become weak, the Remote Active LED flashes. If the Remote Control does not work properly, the batteries may be weak. • When replacing batteries, replace both batteries with new ones. Do not mix different types of batteries together. • When you remove the batteries, any manufacturer codes you've programmed may be erased. To program the Remote Control again, see "Programming Your Remote Control" on page 51. 2 Insert two size AA batteries (supplied). Be sure to match the + and - marks on the batteries with the + and - marks inside the battery compartment. 3 Close the cover. Insert the tabs on the cover into the gaps in the rear of the battery compartment. Then, lower the cover onto the Remote Control until you hear the latch click. Parts, Controls, and Functions 13