Sony SVR-2000 Setup Guide - Page 58

Symptom My channels aren't changing. (continued) Solution If you use a satellite set-top box with a Serial Control cable: • Make sure the set-top box is turned on. • Is the Serial Control cable plugged into the upper serial jack on the back of the SVR Recorder? • Make sure that the Serial Control cable is connected to the "low speed data" jack on the back of the satellite set-top box. • Unplug the satellite set-top box from the wall, then plug it back in. If you are using an RCA satellite set-top box, use your RCA set-top box's remote control to specify low speed data. To do this, press the MENU button on the RCA settop box's remote -> Options -> System Options -> Data Port -> Low Speed Data. If you use a satellite set-top box with an IR Control cable: • Make sure the set-top box is turned on. • Is the IR Control cable plugged into the lower IR jack on the back of the SVR Recorder, not the cable box. • Is the IR Emitter positioned so that it covers the IR window on your satellite box? • Did you select a working code from the list of codes for your satellite box during Guided Setup? To verify this, use the TiVo button to go to TiVo Central -> Messages & Setup -> Cable/Satellite Box -> Control Cable Setup. Once you find a code that changes your channels, press the SELECT button on the Remote Control to choose that code. 58 Troubleshooting