TEAC DM-4800 DM-4800 & DM-3200 Automation Guide - Page 14
Automation overview : AUTO CONFIG - reset
View all TEAC DM-4800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
3 - Automation overview : AUTO CONFIG The other on-screen buttons, etc. work in the same way as for other libraries, allowing deletion, protection, etc. of stored entries. DELETE permanently erases the contents of the highlighted mix file. CAUTION There is no undo for this operation. AUTO CONFIG Figure 8: AUTO CONFIG display The grid represented in the AUTO CONFIG display is used for manual override of the automation's mode switching. The selected channel is displayed in the upper left of the display. If the displayed channel is part of a group, this is indicated in the upper right of the grid. The changes made in this grid are applied to channel and controls selected by the APPLY TO buttons at the right of the display. Use the rightmost POD encoder to make this selection. Note that it is not necessary to press ENTER to confirm this setting. When a module or control is set to any mode except Auto using this display, that module or control remains in that mode until it is reset back to Auto. The settings made in this display are saved as part of the mix data. NOTE Image settings are part of the PAN control setting. MODULE When selected, the changes in this dis- play will only be applied to the specified control on the selected channel. ALL MODULE When selected, the changes in this display are applied to a single control across all channels. For example, with ALL MODULE selected, enabling SAFE in the FADER row places all mixer faders into Safe mode. ALL CNTRLS When selected, the changes in this display are applied to all controls on the selected channel. This applies the changes to the libraries. ALL When selected, the changes in this display are applied to all controls on all channels. COPY This soft key copies the configuration of the currently-selected channel into a special clipboard where it can then be pasted to another channel. A popup message appears when this operation is carried out. PASTE This soft key (only visible when a configu- ration has been copied) pastes the configuration copied using the COPY soft key to the currently-selected channel. Note that there is no Undo for this operation. REVERT The revert function provides a smooth transition between the events being written and existing mix moves. Naturally, this only applies to continuous controls, such as faders and pans (there is no smooth transition that can be made between the on state and the off state of a switch). See "Revert Time " on page 16, "Auto Revert Choices " on page 16, and also "Disabling Auto Revert" on page 19. 14 TASCAM DM Automation Guide