Home » TEAC Manuals » Audio Mixers » TEAC DM-4800 » Manual Viewer

TEAC DM-4800 DM-4800 & DM-3200 Automation Guide - Page 29

key. In this case, all

Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

4 - Operation : Trimming Mix Moves Disabling AUTO REVERT - TRIM allows you to manually stop trimming mix moves by stopping the timecode or by pressing the REVERT key. In this case, all controls that are trimming mix moves will stop trimming simultaneously when REVERT is pressed or timecode stops. Existing Fader Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Revert +6 Time +3 0 -3 -6 -9 -12 Fader Movement Touch Fader Release Fader Press REVERT Figure 26: Trimming fader moves with Auto Revert disabled Existing POD Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Revert +6 Time +3 0 -3 -6 -9 -12 Move & Release POD Press REVERT Figure 27: Trimming POD and encoder moves with Auto Revert disabled TASCAM DM Automation Guide 29

Section	Page
Contents	3
List of Figures	3
1 - Introduction	4
Using This Manual	4
Automated Controls	4
A Note on Touch-Sensitive Faders	5
Setup	5
Timecode	5
MTC	5
2 - Starting out with the timecode	6
Access the automation screens	6
Turn on the automation	6
Make the initial settings	7
Store the current settings	7
Write some fader moves	7
Write some mute moves	7
Write some Aux send moves	8
Writing encoder or POD moves	8
Trimming existing mix moves	8
Finishing up	8
3 - Automation overview	9
Modes	9
Auto	9
Write	9
Trim	10
Static	10
Safe	10
Off	10
Rehearse	11
Displays	11
AUTO SETUP	11
AUTO FILES	13
AUTO CONFIG	14
REVERT	14
Undo/Redo	15
Channel LED Indicators	15
4 - Operation	16
Setting Up Your Mix	16
Writing Mix Moves	16
Revert Time	16
Write To End:	21
Writing Switch Events	23
Revert Time	23
CONTROL SENSE TIME OUT & Switch Events	23
Auto Revert Choices:	24
Write To End:	26
Trimming Mix Moves	27
Trim all	27
Revert Time:	27
Auto Revert Choices:	28
Trim To End	30
Initial Status	32
Initial Data	32
Editing the Initial Status	32
Automating Library Recall	34
Writing Library Recall Events Over Existing Static Control Positions	34
Combining Library Recall With Dynamic Mix Moves	34
Automating Groups	35
Grouping Non-Automated Controls	35
Grouping Automated Controls	35
Hierarchical Groups	35
Mix File Management	35