TEAC DM-4800 DM-4800 & DM-3200 Automation Guide - Page 28
Trimming fader moves with Auto Revert enabled, Trimming POD and encoder moves
View all TEAC DM-4800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
4 - Operation : Trimming Mix Moves Auto Revert Choices: With AUTO REVERT - TRIM enabled, the automation system stops trimming mix moves automatically per control without the need to stop trimming manually. In this case, controls stop trimming mix moves at different times, depending on when they were released (faders) or when movement ended (POD controls), or when the timecode was stopped. In the case of the touch-sensitive faders, the revert starts when the fader is released. In the case of POD controls and encoders, revert starts when the CONTROL SENSE TIME OUT has expired without movement of the control. CONTROL SENSE TIME OUT allows the POD controls to respond as if they are touch-sensitive even though they are not. When a Revert occurs, the control smoothly matches back to its previous data based on the amount of Revert Time set. That previous data could be a control's Static position or a control's Dynamic mix moves. See the diagrams below to understand how this works: Existing Fader Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Revert +6 Time +3 0 -3 -6 -9 -12 Raise Fader Hold Fader Release Fader or Stop Timecode Figure 24: Trimming fader moves with Auto Revert enabled Existing POD Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 Revert +6 Time +3 0 -3 -6 Control -9 Sense -12 Timeout Move POD POD Movement Release POD Time out or Stop Timecode Figure 25: Trimming POD and encoder moves with Auto Revert enabled 28 TASCAM DM Automation Guide