Home » TEAC Manuals » Audio Mixers » TEAC DM-4800 » Manual Viewer

TEAC DM-4800 DM-4800 & DM-3200 Automation Guide - Page 25

controls that are writing will stop writing simulta

Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

4 - Operation : Writing Switch Events Disabling Auto Revert allows you to stop writing switch events manually, either by stopping the timecode or by pressing the REVERT key. In this case, all controls that are writing will stop writing simulta- neously when REVERT is pressed or when timecode stops. See the diagram below to understand this behavior: 1 sec 2 sec Switch ON Existing Switch Events 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec Switch ON Switch ON Switch OFF Switch OFF New Switch Events 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec Switch OFF 1 sec 2 sec Switch ON Resulting Switch Events Press REVERT 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec Switch ON Switch OFF Figure 22: Writing new switch events over previous switch events with Auto Revert disabled TASCAM DM Automation Guide 25

Section	Page
Contents	3
List of Figures	3
1 - Introduction	4
Using This Manual	4
Automated Controls	4
A Note on Touch-Sensitive Faders	5
Setup	5
Timecode	5
MTC	5
2 - Starting out with the timecode	6
Access the automation screens	6
Turn on the automation	6
Make the initial settings	7
Store the current settings	7
Write some fader moves	7
Write some mute moves	7
Write some Aux send moves	8
Writing encoder or POD moves	8
Trimming existing mix moves	8
Finishing up	8
3 - Automation overview	9
Modes	9
Auto	9
Write	9
Trim	10
Static	10
Safe	10
Off	10
Rehearse	11
Displays	11
AUTO SETUP	11
AUTO FILES	13
AUTO CONFIG	14
REVERT	14
Undo/Redo	15
Channel LED Indicators	15
4 - Operation	16
Setting Up Your Mix	16
Writing Mix Moves	16
Revert Time	16
Write To End:	21
Writing Switch Events	23
Revert Time	23
CONTROL SENSE TIME OUT & Switch Events	23
Auto Revert Choices:	24
Write To End:	26
Trimming Mix Moves	27
Trim all	27
Revert Time:	27
Auto Revert Choices:	28
Trim To End	30
Initial Status	32
Initial Data	32
Editing the Initial Status	32
Automating Library Recall	34
Writing Library Recall Events Over Existing Static Control Positions	34
Combining Library Recall With Dynamic Mix Moves	34
Automating Groups	35
Grouping Non-Automated Controls	35
Grouping Automated Controls	35
Hierarchical Groups	35
Mix File Management	35