TEAC DM-4800 DM-4800 Effects List
TEAC DM-4800 Manual
 |
View all TEAC DM-4800 manuals
Add to My Manuals
Save this manual to your list of manuals |
TEAC DM-4800 manual content summary:
- TEAC DM-4800 | DM-4800 Effects List - Page 1
» D00959010A DM-4800 Digital Mixing Console EFFECT LIST - TEAC DM-4800 | DM-4800 Effects List - Page 2
TASCAM FX2.0 Presets 25 DISTORTION FX2.0 25 MONO DELAY FX2.0 25 STEREO DELAY FX2.0 26 PHASER FX2.0 26 MONO CHORUS FX2.0 27 STEREO CHORUS FX2.0 27 MONO FLANGER FX2.0 27 STEREO FLANGER FX2.0 28 COMPRESSOR FX2.0 28 EXCITER FX2.0 29 DE-ESSER FX2.0 29 PITCH SHIFTER FX2.0 30 TASCAM DM-4800 - TEAC DM-4800 | DM-4800 Effects List - Page 3
TASCAM FX2.0 Effect Parameters MONO CHORUS FX2.0 This chorus effect features mono-in (one input) and stereo-out (two outputs). Table 1.1: Mono and onset of the effect sound. Using this parameter enables you to make interesting sound at discontinuous points by smoothening TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 4
channel feedback amount R FbkAmt Linked, 0% - 90% (1% steps) Specifies amount of delay line output signal returned to delay line input. L channel LFO L LfoType waveform type Off, Sine, Triangle, Sawtooth Up, Sawtooth Specifies LFO waveform Down, Square type. Remarks Remarks TASCAM DM-4800 - TEAC DM-4800 | DM-4800 Effects List - Page 5
feed In X-Feed amount 0% - 100% (1% steps) Specifies amount of L (R) channel input signal sent to R (L) channel delay line. Cross feedback Fbk X-Feed 0% - 100% (1% steps) amount Specifies amount of L (R) channel feedback signal sent to R (L) channel feedback path. TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 6
is output from R channel. With 100%, L channel wet signal is output from R channel and R channel wet signal is output from L channel. Specifies mix ratio of dry feedback delay signal and LFO modulation signal. MONO FLANGER FX2.0 This flanger effect features mono-in and stereo-out. It uses - TEAC DM-4800 | DM-4800 Effects List - Page 7
depth Specifies LFO modulation depth. R channel pre-delay R PreDly Linked, 0 ms - 500 ms (0 ms - 9.99 ms: 0.01 ms steps; 10 ms - 99 ms: 1 ms steps; 100 ms - 500 ms: 10 ms steps) Specifies time between onset of original sound and onset of the effect sound. Remarks TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 8
amount of delay line output signal returned to delay line input. Remarks L channel LFO L LfoType waveform sound at discontinuous points by smoothening out edges of sawtooth or square waveform. R channel dry R L (R) channel input signal sent to R (L) channel delay line. TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 9
channel wet channel outputs. signal is output from L channel, and R channel wet signal is output from R channel. With 100%, L channel wet signal is output from R channel and R channel wet signal is output from L channel. Specifies mix will be applied lightly. TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 10
Parameter Indicator Monitor source Output Monitor Range Audio Path, Side Band Description Specifies whether to monitor signal output that passed through deesser, or to monitor sideband signal kHz (1 cent steps) Specifies high-pass filter Band 1 corner frequency. 10 TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 11
Band 3 corner frequency. MONO DELAY FX2.0 This mono delay enables you to set output pan Wet Pan 100%L - Center - 100%R (1% steps) Specifies pan for wet (delayed) audio output. Dry signal output pan Dry Pan 100%L - Center - 100%R (1% steps) Specifies pan for dry audio output. TASCAM DM-4800 - TEAC DM-4800 | DM-4800 Effects List - Page 12
Frequency, HFD Gain, Both Frequency, Both Gain Selects a parameter that is influenced by envelope follower output. Parameter value will change according to value of the envelope follower. The maximum (or minimum) generated by a gate that frequently opens and closes. 12 TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 13
you to create a multi-tap delay sound using five delay taps. Table 1.8: Stereo Delay parameters output from this tap delay. Tap 2 delay time Tap2 DlyTime Off - 1350 ms (1 ms steps) Specifies delay time of delay tap. With Off, no audio signal will be output from this tap delay. TASCAM DM-4800 - TEAC DM-4800 | DM-4800 Effects List - Page 14
Tap 6 gain amount Tap6Gain 0% - 100% (1% steps) Tap 7 gain amount Tap7Gain 0% - 100% (1% steps) 14 TASCAM DM-4800 Effect list Description Specifies delay time of delay tap. Remarks With Off, no audio signal will be output from this tap delay. Specifies delay time of delay tap. With Off, no - TEAC DM-4800 | DM-4800 Effects List - Page 15
drive Routing Asymmetry Morph Pre EQ type Pre low filter gain Pre mid filter gain Table 1.9: Mono Distortion 100.0% (0.1% steps) Specifies mix balance between preamp distortion and power amp distortion when Routing is set to PreAmp+PwrAmp. If the value gain. TASCAM DM-4800 Effect list 15 - TEAC DM-4800 | DM-4800 Effects List - Page 16
gain Harmonic Gain 0% - 100% (1% steps) Specifies gain of harmonics generated before they are mixed with dry audio signals. Harmonics balance HarmonicBal 0% - 100% (1% steps) Sets balance between harmonics of frequency components below and above crossover points. 16 TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 17
and positive mix balance Yin/Yang Mix 0% - 100% (1% steps) Sets relative balance between negative and positive sides before mix. Negative inversion Determines whether or not the output phase of the audio path of positive all-pass filter will be inverted. Remarks TASCAM DM-4800 Effect list 17 - TEAC DM-4800 | DM-4800 Effects List - Page 18
a synthesizer. Crossfade time Crossfade 30 ms - 100 ms (1 ms steps) Specifies buffer size assigned by sawtooth waveform. Longer crossfade time would reduce unnaturalness but increase group delay. 18 TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 19
s - 64.00 s 0.25 s - 64.00 s 4 s, 16 s, 64 s Crossover point X-over LOW 20 Hz - 16 kHz Specifies decay time for low band. Specifies decay time for mid band. Specifies decay time for high band. Selects decay time range. Specifies crossover point between low and mid bands. Remarks TASCAM DM-4800 - TEAC DM-4800 | DM-4800 Effects List - Page 20
initial reflection level. Specifies level of reverb decay curve. Specifies delay time until initial reflection starts. Specifies delay time until reverb decay curve starts. 20 TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 21
- Bright Box- Dark Chmb- Large, Dark Chmb- Small Chmb- Small, Dark Chmb- Very Small FX- BigBarrelSpce FX- BigPreDlySlap FX- BrightCymbals FX- DrumBoom Slap FX- DryAfterTaste TASCAM DM-4800 Effect list 21 - TEAC DM-4800 | DM-4800 Effects List - Page 22
Steel Works 2 029 FX - Subtle Slapback 030 FX - Take Off 031 FX - Tight Bounce Around 032 FX - Ultra Bright 033 FX - Under The Surface 034 FX - Wet 055 Hall - Outside the Stadium 056 Hall - Small Bright 22 TASCAM DM-4800 Effect list Indicator FX- Icy Shower FX- Lost in Space FX- - TEAC DM-4800 | DM-4800 Effects List - Page 23
- Perc Room 091 Room - Small Room- Small 092 Room - Small Damped Room Room- S Dmp Room 093 Room - Small Yet Big Room- SmallYetBig Effect preset list TASCAM DM-4800 Effect list 23 - TEAC DM-4800 | DM-4800 Effects List - Page 24
Room - Vocal Room 099 Room - Vocal Room 2 Indicator Room- S.Y.B w_Pre Room- Stage Room- Vocal Booth Room- Vocal Dry Room- Vocal Room Room- Vocal Room2 24 TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 25
(#10) for insert Sizzle Delay (#11) for insert ENV Panning Delay (#12) for insert Short delay with the pan setting of" L: Dry" and" R: Wet" expands mono sound to stereo image. TASCAM DM-4800 Effect list 25 - TEAC DM-4800 | DM-4800 Effects List - Page 26
flows the output of each channel into Use this phaser on a keyboard or synthesizer for a lighter effect. Use this phaser on a keyboard or synthesizer for more effect. Use this phaser on a keyboard or synthesizer for a deeper effect. This phaser creates a strange, unusual effect. 26 TASCAM DM-4800 - TEAC DM-4800 | DM-4800 Effects List - Page 27
Horror Hit (AUX) SpaceLaser (AUX) EarlyReflct (AUX) MONO FLANGER FX2.0 63 Basic Flanger Mono 64 Light Flanger Mono 65 Deep Flanger Mono 66 Mu-Tron Flanger 67 Light Phasing 68 Deep Phasing ascending sound. This flanger simulates a metallic glitch sound. TASCAM DM-4800 Effect list 27 - TEAC DM-4800 | DM-4800 Effects List - Page 28
to a vocal. This compressor adds remarkable compression to a vocal. Use this limiter for vocal parts that contain significant level differences, such as sound pressure. This setting significantly enhances attack. Use it for drum loops to emphasizes strong attack. 28 TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 29
for a man's voice. Frequency target of this de-esser is adjusted for a man's voice. Frequency target of this de-esser is adjusted for a man's voice. TASCAM DM-4800 Effect list 29 - TEAC DM-4800 | DM-4800 Effects List - Page 30
shifter simulates organ glissando. This pitch shifter creates a 70's space age type special effect. This pitch shifter creates a 70's space age type special effect. 30 TASCAM DM-4800 Effect list - TEAC DM-4800 | DM-4800 Effects List - Page 31
Notes TASCAM DM-4800 Effect list 31 - TEAC DM-4800 | DM-4800 Effects List - Page 32
» DM-4800 TEAC CORPORATION Phone: +81-422-52-5082 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan TEAC AMERICA, INC. Phone: +1-323-726-0303 7733 Telegraph Road, Montebello, California 90640 TEAC CANADA LTD. Phone: +1905-890-8008 Facsimile: +1905-890-9888 5939 Wallace Street, Mississauga,
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
 |
 |
ยป
DM-4800
Digital Mixing Console
D00959010A
EFFECT LIST