TEAC DM-4800 DM-4800 Effects List - Page 15

Parameter Tap 8 gain amount Indicator Tap8Gain Range 0% - 100% (1% steps) Effect parameter list Description Specifies amount of audio signals feedback from this tap to delay input. Remarks DISTORTION FX2.0 This mono distortion enables pre-amp or power amp modeling. Parameter Pre-amp gain Pre-amp drive Power amp gain Power amp drive Routing Asymmetry Morph Pre EQ type Pre low filter gain Pre mid filter gain Table 1.9: Mono Distortion parameters Indicator Range PreAmpGain 0.00 - 11.00 (0.01 steps) Description Specifies input gain at pre-amp section. Remarks With the maximum setting (11.00), the input signal gain is multiplied 110 times. PreAmp Drive 0.00 - 11.00 (0.01 steps) Sets distortion at preamp section. PwrAmp Gain 0.00 - 11.00 (0.01 steps) Specifies input gain at power amp section. With the maximum setting (11.00), the input signal gain is multiplied 110 times. PwrAmp Drive 0.00 - 11.00 (0.01 steps) Sets distortion at power amp section. Routing PreAmp+PwrAmp, PreAmp->PwrAmp, PwrAmp->PreAmp, PreAmp, PowerAmp Sets distortion routing. Asymmetry -100.0% - 100.0% (0.2% steps) Adjusts DC offset at power amp section. Morph 0.0% - 100.0% (0.1% steps) Specifies mix balance between preamp distortion and power amp distortion when Routing is set to PreAmp+PwrAmp. If the value is closer to 0%, more power amp distortion, and if it is closer to 100%, more pre-amp distortion. PreEq Type Parametric, Shelving, Stack, Big Bottom, Wide, Phat Mid Selects a preset combination of pre filter frequency and Q. Pre Low -15 dB - +15 dB (0.1 dB steps) Specifies pre low filter gain. Pre Mid -15 dB - +15 dB (0.1 dB steps) Specifies pre mid filter gain. TASCAM DM-4800 Effect list 15