TEAC NR-7CD Owners Manual English Francais Espanol - Page 7
Before use, Maintenance, Using the remote control, Note about pinpoint feet, Precautions for use
View all TEAC NR-7CD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Before use Using the remote control VVPlacement precautions Precautions for use oo Do not install this unit in a location that could become hot. This includes places that are exposed to direct sunlight or near VVMisuse of batteries could cause them to rupture or a radiator, heater, stove or other heating equipment. Moreover, leak, which might result in fire, injury or the stain- EN do not place it on top of an amplifier or other equipment that generates heat. Doing so could cause discoloration, deformation or malfunction. ing of nearby materials. Please carefully read and observe the precautions on page 3. oo When installing this unit, leave a little space (at least 3 cm or 1") between it and walls and other devices in order to allow good heat dissipation. If you put it in a rack, for example, leave at least 5 cm (2") open above it and at least 10 cm (4") open behind it. Failure to provide these gaps could cause heat to build up inside and result in fire. Note about pinpoint feet oo When using the remote control, point it toward the remote control signal receiver on the main unit from a distance of 5 m (16 ft) or less. Do not place obstructions between the main unit and the remote control. oo The remote control might not work if the remote control signal receiver on the unit is exposed to direct sunlight or bright light. If this occurs, try moving the unit. oo Beware that use of this remote control could cause the unintentional operation of other devices that can be controlled by infrared rays. High-precision metal pinpoint feet are attached firmly to the bottom plate of this unit. The stands for these feet are loose, but when the unit is placed in position, it is supported by these pinpoint feet, which will effectively disperse vibrations. Chassis Pinpoint foot (metal) Installing batteries Remove the cover from the back of the remote control and insert two AAA batteries with their ¥/^ oriented as shown in the case. Replace the cover. Foot-stand (metal) Screws that attach foot-stand oo The included felt pads are intended to protect the surface where the unit is placed. Apply them to the bottoms of the foot-stands. Maintenance Wipe dirt from the top cover and other panel surfaces using a soft cloth that has been slightly dampened with a diluted neutral cleanser. Do not wipe with chemical cleaning cloths, thinner or other chemical agents. Doing so could damage the surface. VVFor your safety, disconnect the power cord from the outlet before cleaning. When to replace batteries If the distance required between the remote and the main unit decreases or if the unit stops responding to the remote buttons, replace both batteries with new ones. Dispose of the used batteries according to the instructions on them or requirements set by your local municipality. 7