TEAC PE-505 Owners Manual English Francais Espanol - Page 9
Using an RCA-XLR conversion cable for balanced connection of an MC cartridge, Not good - phono
View all TEAC PE-505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
A Phono input connectors (INPUTS) Using an RCA-XLR conversion cable for Connect the audio outputs of an analog turntable. balanced connection of an MC cartridge oo The XLR connectors are only for use with MC cartridges. Use audio cables to connect the R and L connectors on an When using an RCA-XLR conversion cable for balanced connection of an MC cartridge, only the following types of analog turntables EN analog turntable to the corresponding R and L connectors on can be connected to this unit: turntables in which the cartridge − this unit. and the tone arm GND are not connected inside it, and turntables in which the L/R − are isolated. Use the following types of commercially-available cables for connections. OK XLR: XLR cables Analog Analog PE-505 Phono input RCA: RCA cables turntable audio output connectors (RCA) connectors (XLR) B Analog audio output connectors (LINE OUT) To cartridge L+ L To cartridge L- These connectors output audio. Connect these to the audio input connectors (e.g. LINE IN) on an amplifier. To GND To cartridge R- To cartridge R+ GND RCA-XLR conversion cables R Use the following types of commercially-available cables for connections. XLR: XLR cables RCA: RCA cables oo Do not connect the analog audio output connectors on this unit to phono input connectors on an amplifier. Be sure to connect them to line input connectors. C Power inlet (~IN) Connect the supplied power cord here. After all other connections are complete, connect the power cord's plug to a wall outlet. VVDo not use any power cord other than the one included with this unit. Use of other power cords could result in fire or electric shock. VVDisconnect the power plug from the outlet if you will not use the unit for a long time. D Grounding terminal (FRAME GND) If the L/R − and tone arm GND are connected within the analog turntable, a humming sound might be heard. Not good Analog Analog turntable audio output connectors (RCA) PE-505 Phono input connectors (XLR) To cartridge L+ L To cartridge L- To GND To cartridge R- To cartridge R+ GND RCA-XLR conversion cables R oo When the L/R − and tone arm GND are connected within the analog turntable, using an RCA-XLR conversion cable might not reduce the humming sound. oo When connected with an analog turntable that has a built-in phono equalizer amplifier, turn the phone equalizer amplifier output off during use. Connect an audio output cable from an analog turntable to the grounding terminal. Connecting the grounding terminal also to the amplifier might improve sound quality. oo Failure to connect the grounding terminal of an analog turntable might cause hum (a low continuous noise). E Maintenance port This is used for maintenance. Do not connect anything to this port unless instructed to do so by our service department. 9