TEAC TA-TS30UN Owners Manual - Page 4
Preparing the record player, Precautions for use, Maintenance, Product registration
View all TEAC TA-TS30UN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Before use (continued) Precautions for use ooDo not place anything on the turntable cover. Objects on the cover might cause noise due to vibrations or fall off, especially during playback. Maintenance If the surface of the unit gets dirty, wipe it with a soft cloth or use diluted mild liquid soap. Allow the surface of the unit to dry completely before using. ooAvoid placing the unit in direct sunlight, close to a source of heat or in other similar conditions. Do not place the unit on top of an amplifier or other equipment that might generate heat that exceeds the operating temperature range of this unit. Doing so could cause discoloration, deformation or malfunction. ooAs the unit could become warm during operation, always leave sufficient space around it for ventilation. When installing this unit, leave a little space (at least 20 cm (8")) between it and other devices and walls to allow good heat dissipation. When placing it in a rack, for example, leave at least 35 cm (13 3/4") open above it and 10 cm (4") open behind it. Failure to provide these gaps could cause heat to build up inside and result in fire. ooDO NOT MOVE THE UNIT DURING PLAYBACK. During playback, the record rotates. Do not lift or move the unit during playback. Doing so may damage the record, the stylus, the cartridge or the unit. ooAlways remove the record before relocating or moving this unit. Moving the unit with a record on the turntable could damage the record, the stylus and the cartridge or could cause a malfunction. ooThe voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician. ooDo not use chemical cleaning cloths, thinner or similar substances as they could damage the surface of the unit. VV CAUTION For safety, disconnect the power cord from the socket before cleaning. Product registration Customers in the USA, please visit the following TEAC website to register your TEAC product online. http://audio.teac.com/support/registration/ Using the TEAC Global Site You can download updates for this unit from the TEAC Global Site: http://teac-global.com/ 1) Open the TEAC Global Site. 2) In the TEAC Downloads section, click the desired lan- guage to open the Downloads website page for that language. NOTE If the desired language does not appear, click Other Languages. 3) C lick the "Search by Model Name" section to open the Downloads page for that product. (Users in Europe should click the product name in the "Products" section instead.) 4) Select and download any updates that are needed. 4 Preparing the record player Keep the unit in standby while setting it up ( E on page 6). 1 Place it on a flat surface. Since the heights of this unit's feet cannot be adjusted, be sure to place it on a flat surface. 2 Install the turntable. Align the turntable with the center shaft and install it. 4 Place the rubber mat. Place the protective rubber mat that is included with the turntable on it before use. Top Center shaft Turntable 3 Loop the belt around the motor pulley. Use a finger to pull the rubber belt that is wrapped around the sub-platter through the round opening and loop it around the motor pulley. ooBe careful not to let the rubber become twisted. ooRotate the turntable several times to make sure that it is secure. ooThe rubber mat has a top and a bottom. As shown in the illustration, the side with the ridged concentric circles should be placed down. 5 Install the counterweight. Place the counterweight over the end of the tone arm and turn it clockwise to tighten it. Counterweight Round opening Motor pulley Rubber belt 6 Install the headshell. Insert the headshell on the end of the tone arm and turn the nut to secure it in place. Nut Headshell