TEAC TA-TS30UN Owners Manual - Page 8

Changing the cartridge To change the cartridge, first remove the headshell from the tone arm. ooWe recommend that you keep the cartridge needle protective cap on while changing the cartridge. Headshell Screws Nuts Shell leads Cartridge 1 Disconnect the shell lead terminals from the cartridge. 2 Loosen the screws and remove the cartridge. 3 Attach the new cartridge and tighten the screws. See the illustration below for the position of the screws when attached. 4 Connect the shell lead terminals to the cartridge. ooThe signals and colors of the shell leads are shown below. Signal Left channel + Left channel − Right channel + Right channel − Color White Blue Red Green 5 Balance the tone arm and adjust the stylus pressure. Follow the procedures in "Balancing the tone arm and adjusting the stylus pressure" on page 5. 2.0 ± 0.5 mm Basic operation Playing records 1 Press the STANDBY/ON button on the back of the unit to turn it on. 4 Set according to the rotation speed (RPM) of the record. The rotation speed can be set to 33 1/3 or 45 RPM. 2 Open the turntable cover slowly. 5 Turn the START/STOP rotation knob to START to start the turntable. VV Be careful not to pinch your hand, for example, when opening and closing the turntable cover. 3 Place a record on the turntable. When playing a 45 RPM large-hole single record, use the included adapter. NG ooWhen the START/STOP rotation knob is set to START, the turntable will start rotating and the blue LED will light. 6 Move the tone arm clasp to the right to release the tone arm. TI-SKATI AN 0 3 Clasp 8