TEAC TN-570 Owner s Manual - Page 17

Connections When PHONO EQ is ON E Connect to audio input connectors of amplifier, etc. A BC D FG H Included AC adapter When PHONO EQ is THRU Connect to PHONO inputs of amplifier, etc. |R L Amplifier DIGITAL IN (OPTICAL) Digital audio input device VV Precautions when making connections oo Do not plug the unit in until after making all connections. oo Carefully read the manuals of the devices that you are connecting and follow their instructions when making connections. A PHONO EQ (audio output setting) switch ON Signals that have been amplified by the builtin phono equalizer amp, which supports MM cartridges, are output from the analog audio output connectors (L/R). THRU The MC or MM cartridge signal is output directly through the analog audio output connectors (L/R). Use this when connecting to equipment that has PHONO inputs. oo When shipped new from the factory, this is set to ON. oo Set this to ON if a device is connected to the OPTICAL digital audio output connector or the USB port. CAUTION When set to ON, if connected to the PHONO inputs of an amplifier, for example, the output from speakers and headphones will be very loud, which could damage equipment or harm hearing. B Digital output selection switch (DIGITAL OUT SEL) Use to select the sampling frequency of the optical digital output. oo The maximum sampling frequency supported is 192 kHz. C USB port (USB B type) Connect this to the USB port of a computer to convert the audio signal from this unit to digital and output it to the computer (page 18). D STANDBY/ON button Press the STANDBY/ON button to turn the unit on or put it in standby. E Grounding connector (|) Use the grounding wire of the included RCA audio cable to connect this connector to the grounding connector of the amplifier, for example. oo This is NOT an electrical safety ground. F Analog audio output connectors (L/R) These output analog audio signals. The PHONO EQ switch setting changes the type of output signal. Use the included RCA audio cable to connect other equipment to the output connectors of this unit. G OPTICAL digital audio output connector This outputs digital audio. Connect this to the optical audio input connector of a device capable of receiving digital audio. Use a commercially-available TOSLINK optical digital cable to make the connection. H DC input connector After completing all other connections, connect the included AC adapter to this connector. Confirm that the power plug of the AC adapter is plugged into a power outlet. oo Unplug the power cord from the outlet when you are not planning to use the unit for an extended period of time. oo Do not use any AC adapter other than the one included. VV Be sure to connect the power cord to an AC outlet that supplies the correct voltage. Connection to an outlet that supplies incorrect voltage could cause fire or electric shock. Hold the power plug when plugging it into an outlet or unplugging it. Never pull or yank on the power cord. Unplug the power cord from the outlet when you are not planning to use the unit for an extended period of time. Basic operation Playing records 1 Press the STANDBY/ON button on the back of the unit to turn it on. 2 Open the turntable cover slowly. VV Be careful not to pinch your hand, for example, when opening and closing the turntable cover. 3 Raise the cartridge protector. Protector 4 Place a record on the turntable. When playing a 45 RPM large-hole single record, use the included adapter. Continued on the next page e 17 ENGLISH