TEAC TN-570 Owner s Manual - Page 18

3 4 3 4 3 4 0 0 0 5 Set the RPM according to the record and start the turntable. The rotation speed can be set to 33 1/3 or 45 RPM. 6 Shift the tone arm slightly to the left to unlock it. 1 2 Basic operation (continued) 9 Lower the arm lifter. Lower the tone arm slowly until the stylus touches the record and playback begins. oo We recommend that you close the turntable cover during record playback to avoid dust. VV Do not place anything on top of the turntable cover. CAUTION oo During playback, do not touch the tone arm or the rotating record. oo Do not stop turntable rotation during playback. During record playback, feedback could occur if the volume is too loud. If this happens, lower the volume of the amplifier. 7 Raise the arm lifter. 1 2 When playback finishes 1 Raise the arm lifter to separate the needle from the record, and return the tone arm to its original position. 1 2 Arm lifter Tone arm 2 Turn the rotation speed setting knob to 0 to stop the turntable. Recording with a computer Connect this record player to a computer using a commercially-available USB cable to convert audio signals from a record to digital data and send them to the computer. Supported operating systems Computers running the following operating systems can be connected by USB to this unit (as of November 2015). Windows OS Windows 7 (32-bit, 64-bit) Windows 8 (32-bit, 64-bit) Windows 8.1 (32-bit, 64-bit) Windows 10 (32-bit, 64-bit) Mac OS X OS X Lion 10.7 OS X Mountain Lion 10.8 OS X Mavericks 10.9 OS X Yosemite 10.10 OS X El Capitan 10.11 Use with operating systems other than these is not guaranteed. oo This unit will run with the standard OS driver, so there is no need to install a special driver. Arm lifter Tone arm oo You can also move the tone arm to above the record without raising the arm lifter and then slowly lower the tone arm to start playback. 8 Move the tone arm to the edge of the record or the track where you want to start playback. 18